Philips TV Antenna SDV7225T 27 User Manual

Register your product and get support at  
SDV7225T/27  
EN User manual  
 
Relocate the receiving antenna.  
1 Important  
Increase the separation between  
equipment and receiver.  
Connect the equipment into an outlet on  
a circuit different from that to which the  
receiver is connected.  
Safety  
This manual contains important information  
about the Philips indoor television antenna.  
Read it carefully before you start the installation  
and setup.  
Consult the dealer or an experienced  
radio/TV technician for help.  
All other devices shall bear the following  
statement in a conspicuous location on the  
device:  
The product shall not be exposed to  
dripping or splashing and that no objects  
filled with liquids, such as vases, shall be  
placed on the product.  
This device complies with part 15 of the FCC  
Rules. Operation is subject to the following  
two conditions: (1)This device may not cause  
harmful interference, and (2) this device must  
accept any interference received, including  
interference that may cause undesired  
operation.  
To completely disconnect the power  
input, the mains plug of the product shall  
be disconnected from the mains.  
Where the mains plug is used as the  
disconnect device, the disconnect device  
shall remain readily operable.  
No naked flame sources, such as lighted  
Notice for Canada  
candles, should be placed on the product.  
Class B Clause  
Notice for USA  
This digital apparatus does not exceed the Class  
B limits for radio noise emissions from digital  
apparatus as set out in the Radio Interference  
Regulations of the Canadian Department of  
Communications.  
This equipment has been tested and found  
to comply with the limits for a Class B digital  
device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation.This equipment generates,  
uses and can radiate radio frequency energy  
and, if not installed and used in accordance  
with the instruction manual, may cause harmful  
interference to radio communications.  
This Class B digital apparatus complies with  
Canadian ICES-003.  
Recycling  
However, there is no guarantee that  
interference will not occur in a particular  
installation. If this equipment does cause harmful  
interference to radio or television reception,  
which can be determined by turning the  
equipment off and on, the user is encouraged  
to try to correct the interference by one or  
more of the following measures:  
Your product is designed and manufactured  
with high quality materials and components,  
which can be recycled and reused.  
Never dispose of your product with other  
household waste. Please inform yourself about  
the local rules on the separate collection of  
4
EN  
 
 
electrical and electronic products.The correct  
disposal of your old product helps prevent  
potentially negative consequences on the  
environment and human health.  
The packaging of this product is intended to  
be recycled. Contact your local authorities for  
information about how to recycle the packaging.  
When this logo is attached to a product, it  
means a financial contribution has been paid to  
the associated national recovery and recycling  
system.  
© 2010 Koninklijke Philips Electronics N.V.All  
rights reserved. Reproduction in whole or in  
part is prohibited without the written consent  
of the copyright owner.Trademarks are the  
property of Koninklijke Philips Electronics N.V.  
or their respective owners.  
EN  
5
 
2 Your  
SDV7225T/27  
Congratulations on your purchase and welcome  
to Philips!  
To fully benefit from the support that Philips  
com/welcome.  
Overview  
a
b
g
d
c
e
f
1
2
3
VHF antenna  
UHF antenna  
Power switch/gain control  
knob  
4
5
6
7
Power indicator  
6V DC connection  
Out to TV connection  
100-240V AC / 6V DC  
power adaptor, included  
6
EN  
 
 
2 Connect the DC plug to the antenna  
and the power supply to a 100-240V AC  
outlet.  
3 Get started  
To ensure the antenna to work properly, read  
the user manual of your television before you  
start. Set the television so that it receives the  
signal from an ANTENNA instead of CABLE or  
SATELLITE.  
Installation  
Determine the signal strength  
Before Installation, determine the best  
location for optimum reception. It is important  
for the antenna to have an unobstructed path  
to the transmitter. For best results, ensure the  
antenna faces the location of the transmitter.  
4 Set up  
SDV7225T/27  
Note  
Choose a location near a window which gives  
the antenna a clear view of the transmitter.  
ForVHF/FM reception  
1 Extend the telescopic dipoles to the  
longest possible length.  
Note  
Place the antenna away from the metal surface  
to avoid interference.  
Connect to theTV  
1 Connect the coaxial cable to the TV.  
2 Turn the TV or FM to the desired  
channel/station. Move the dipoles in  
different directions up and down until the  
reception is achieved.  
EN  
7
 
 
Mount on the wall  
Mount two wood screws onto the wall.  
Ensure the distance between two screws is  
80mm (3.149”).  
3
Turn on the amplifier by rotating the VHF/  
UHF gain control knob towards the max  
position until better reception is achieved.  
Set up a digital tuner with this  
antenna  
You can install available channels with the digital  
TV tuner.This automatic process is part of the  
setup of the tuner. Ensure the antenna has  
set up properly before the tuner can receive  
viewable channels.  
Tip  
For best reception, turn the gain control down  
to a lower setting.  
There are two ways to connect the antenna to  
theTV:  
For UHF reception  
Connect the antenna to a digital tuner.  
If the signal strength is good enough, the  
channels can be memorized in the tuner  
automatically .  
1 Turn the TV to the desired channel/  
station.  
2
To turn the amplifier up, rotate the gain  
control knob towards the max position.  
Connect the antenna directly to the TV.  
Tune to the analogue channels and find  
the best antenna location. Then re-  
connect the antenna to the digital tuner.  
Ensure the signal strength is good enough  
before you install the channels with the  
tuner.  
Note  
It is possible to turn the gain control knob  
down for best reception.  
8
EN  
 
 
5 Frequently  
6 Warranty and  
service  
asked questions  
Can this antenna work with Analog  
transmissions?  
Warranty information can be found at: www.  
philips.com/welcome  
Yes, this antenna can receive analog television  
broadcasts in the UHF and VHF bandwidths.  
For technical support, send us an email  
with the model number of the product  
and a detailed description of your problem  
Can this antenna receive digital or work with  
HD-ATSC broadcasts?  
Yes, this antenna is designed to receive digital  
ATSC and HDTV broadcasts in the UHF &  
VHF bandwidths.  
Can this antenna be powered by a DC power  
supply in a boat, RV or camper?  
Yes, there is a DC power socket on the rear of  
the antenna. Plug the converter/adaptor into  
the antenna and the power source.  
Where should I place the antenna in order to  
get the best reception possible?  
Choose a location near a window which gives  
the antenna a clear view of the transmitter.  
Tip  
For best reception, place the antenna away  
from the metal surface to avoid interference.  
How do I know how much gain (amplification)  
is required to receive a clear picture?  
Once you have the VHF dipoles extended to  
the longest length, turn on the amplifier. Turn  
the amplifier up to the max position and then  
reduce as needed. In some case, you need to  
turn the amplifier down to receive a clearer  
picture.  
Can I set up this antenna with a digital tuner?  
Yes, this antenna can be set up with a digital  
tuner (see the section on “Set up a digital  
tuner with this antenna”).  
EN  
9
 
 
7 Glossary  
H
HDTV (High-Definition Television)  
It is a digital television broadcasting system  
with higher resolution than traditional  
television systems (standard-definition TV,  
or SDTV). HDTV is digitally broadcast;  
the earliest implementations used analog  
broadcasting, but today digital television  
(DTV) signals are used, requiring less  
bandwidth due to digital video compression.  
A
Amplifier  
A device, either a single stage or a large scale  
circuit with multiple stages for creating gain,  
i.e. it makes small signals larger.  
Antenna  
A device, such as a rod or wire, which picks up  
a received radio frequency signal or radiates a  
transmitted RF signal.  
U
UHF (Ultra high frequency)  
In radio or TV broadcasting: it is the frequency  
range of electromagnetic waves which lies  
between 300 MHz and 3 GHz (3000 MHz).  
C
Coaxial  
A single copper conductor, surrounded with  
a layer of insulation, covered by a surrounding  
copper shield and finally, an insulating jacket.  
An unbalanced transmission line with constant  
impedance. In audio, this type is commonly  
used for low level, line signals terminated in  
RCA connectors.  
V
VHF (Very high frequency)  
In radio or TV broadcasting: it is the frequency  
range of electromagnetic waves which lies  
between 30 MHz and 300 MHz.  
D
DVB (Digital Video Broadcasting)  
DVB is a suite of internationally accepted open  
standards for digital television.  
F
FM (Frequency Modulation)  
In radio broadcasting: a method of modulation  
in which the frequency of the carrier voltage  
is varied with the frequency of the modulation  
voltage.  
10 EN  
 
 
 
© 2010 Koninklijke Philips Electronics N.V.  
All rights reserved.  
DFU_SDV7225T_27_V1.0  
 

Phase Technology Speaker IW500i User Manual
Philips CRT Television TR2503C1 User Manual
Philips DVD Recorder DVDR 725H 05 User Manual
Pioneer Car Video System XVHTD1 User Manual
Planet Technology Network Card IPX 1900 User Manual
Planet Technology Switch WSW 2401A User Manual
Polk Audio Speaker System LC80fx User Manual
Poulan Chainsaw 115267626 User Manual
Poulan Snow Blower 416810 User Manual
ProForm Treadmill PFTL995071 User Manual