AJ3225
Clock Radio
User manual
AJ3
2
25
CLOOCCK
D
DUUAALLAALLAARRM
M
C
L
K
R
RAADDIIOO
FM
ALARM
2
SET
TIME
SET
ALAR
M2
SET
ALAR
M1
CLO
CK
ALARM
1
RESET
ALARM RESET
SLEEP
English
CONTROLS
1 SLEEP - activates the radio for sleep function
adjusts the sleep period
-
2 Clock control
- CLOCK : to run on clock time
- SET ALARM 1 : sets the alarm time for alarm 1
- SET ALARM 2 : sets the alarm time for alarm 2
- SET TIME : sets the clock time
- 7 / ∞ : adjusts the hours/ minutes for the clock and alarm times
3
SLEEP OFF /REPEAT ALARM
-
-
switches off the radio sleep function
switches off the active alarm for a 6-7 minute period
4 Frequency indicator - shows the radio frequency of your selected waveband
5 TUNING - tunes to radio stations
6 BAND - select FM/MW (AM or LW) waveband
7 VOLUME - adjusts the sound level
8 ALARM RESET - stops the active alarm for 24 hours
9 DISPLAY - show the clock/ alarm times and status of the set
0 RADIO OFF
/
ON - switches the radio off/on
! ALARM 1 , ALARM 2
–
–
–
OFF switches off the alarm 1 or alarm 2
RAD activates the radio for alarm 1 or alarm 2
BUZ activates the buzzer for alarm 1 or alarm 2
@ Battery door - opens to store a 9 volt 6F22 type battery (not included) for
clock memory backup
# Mains lead - for AC mains supply
$
Pigtail aerial improves FM reception
-
INSTALLATION
POWER SUPPLY
1
Check if the mains supply, as shown on the type plate located on the
bottom of the set, corresponds to your local mains supply. If it does not,
consult your dealer or service centre.
2
3
Connect the mains lead to the wall socket.
To disconnect the set from the mains supply completely, remove the plug from
the wall socket.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. mains failure. The com-
plete clock radio and display illumination will be switched off. As soon as the
mains supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a 9 volt 6F22 type battery (not included) for
backup.
2
Replace the battery door.
NOTE: If no backup battery is installed or the power interruption is prolonged, you
will need to set the clock and alarm times again.
Batteries contain chemical substances so should be disposed of
properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3W
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in unsafe operation.
RADIO
You can use this set solely as a radio!
1
2
3
4
5
Adjust RADIO OFF
Select your waveband by adjusting the BAND switch
Adjust TUNING to tune to your desired station
Turn the VOLUME control to adjust the volume level
Adjust RADIO OFF /ON to OFF to switch off the radio.
/ON to ON to switch on the radio.
.
.
.
To improve reception:
FM:
extend and position the pigtail for optimum reception
uses a built-in aerial inside the set. Direct the aerial by adjusting the
position of your set
.
AM:
.
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 24-hour clock
IMPORTANT! To adjust the clock and alarm times accurately, always make sure
you press the
7
or
∞
buttons separately and not simultaneously.
1
2
Turn the clock control to SET TIME or SET ALARM 1 or SET ALARM 2 to
set the clock or alarm time respectively.
Press
hours and minutes.
Release or when you reach the correct setting.
7
or
∞
repeatedly or hold down on the respective button to adjust the
3
4
7
∞
After you have set both the hour and minutes, turn the clock control to
CLOCK to run on clock time.
SELECTING THE ALARM MODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can choo-
se from two different alarm modes to wake you up: by radio or buzzer.
•
Select your choice of alarm mode by adjusting ALARM 1 or ALARM 2 to RAD
or BUZ.
™
The 2 buzzers are at a set volume and cannot be adjusted. BUZ on
ALARM 1 is a low tone buzzer while BUZ on ALARM 2 is a high tone.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24 hour alarm reset option will be automatically selected after
59 minutes, from the time your alarm time first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain the
same alarm setting for the following day:
•
Press ALARM RESET during the alarm call.
CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the alarm call:
•
Adjust ALARM 1 or ALARM 2 to OFF position.
REPEAT ALARM
This repeats your alarm call at 6-7-minute intervals.
1
During the alarm call, press SLEEP OFF /REPEAT ALARM
Repeat if desired for up to 59 minutes.
.
2
SLEEP
About Sleep
This set has a built-in timer which enables the set to be automatically switched
off during radio playback after a set period of time. This allows you to lie back,
listen and fall asleep. The maximum sleep time is 59 minutes.
Setting SLEEP
1
2
3
Check that the clock control is in CLOCK position.
Set RADIO to OFF position.
Set your sleep time by pressing on the SLEEP button. Keep your finger on the
button and the display will begin to count down from 0:59 to 0:00 minutes.
™
To cancel sleep, or to switch off the sleep period press
SLEEP OFF /REPEAT ALARM
.
AUSTRALIA -
Philips ManufacturersWarranty forAustralia only
These warranty conditions are valid for the
following consumer electronics products:
ColourTelevisions, ProjectionTV, Plasma &
LCDTV, Video Cassette Recorders, CD
Recorders & Players, DVD Players, DVD
Recorders, DVD Recorders with HDD,Audio
Systems, HomeTheatre systems, Digital Set
Top Box & Portable Audio products.
8. This Manufacturers Warranty is neither transferable
nor valid in countries other than Australia.
This warranty does not cover:
a) Mileage or travel outside the normal service area
covered by selected Authorised Service Centre.
b) Service costs arising from failure to correctly
adjust the controls of the product or to observe the
instructions, or inspections that reveal that the
product is in normal working order.
The benefits given to the purchaser by this
warranty are in addition to all other rights
and remedies which the purchaser has in
respect of the product under theTrade
Practices Act or other Commonwealth or
State Law.
c) Product failures caused by misuse, neglect,
accidental breakage, transit damage, inexpert repairs
or modification by un-authorised persons, external
fires, lightning strikes, floods, vermin infestation or
liquid spillage.
Philips Consumer Electronics warrants its products to
the purchaser as follows and subject to the stated
conditions.
d) Cleaning of video or audio heads.
e) Inadequate receiving antennae.
1Year Free Repair Service - at Philips ASC
f) Replacement of worn or used batteries or other
consumables.
ColourTelevision, PlasmaTelevision, LCDTelevision,
ProjectionTelevsion, DVDR/VCR Combo, DVD
Recorders with Hard Drive, LCD Projectors,Wireless
Audio Systems,Audio Systems, HomeTheatre
Systems & Digital Set-Top-Box.
g) Consumer products used in commercial applications
(This warranty is limited to 3 months only).
h) Second hand products.
The conditions contained in this warranty
card replace and override the provision of
the PhilipsWorld-Wide Guarantee for
products purchased in Australia and used in
Australia.
1Year Free Replacement – at your Retailer
Portable Audio, MP3 Infotainment products,Video
Cassette recorders, DVD Player, DVD/VCR Combo
Player, DVD Recorder without HDD & Portable
DVD/LCD players.
Service is provided through more than 100
accredited Authorised Service Centres throughout
Australia. For direct contact with the nearest
recommended Authorised Service Centre in capital
& regional cities/towns
Conditions of RepairWarranty
1. All claims for warranty service should be made to
your nearest Philips Authorised Service Centre or the
PhilipsTechnology Care Centre. Reasonable evidence
of date of purchase must be provided.
Authorised Service Centre Network
1300 361 392
2. This warranty extends only to defects in material or
workmanship occurring under normal use of the product
when operated in accordance with the instructions.
Customer support is provided in Australia by our
trained call centre staff. For assistance with product
features and specifications, please call
3. If a replacement product is supplied under the repair
policy it is warranted for the remainder of the
warranty of the original purchased product only.
Technology Care Centre
1300 363 391
4. Home service is provided only within the normal
service area of one of our recommended Authorised
Service Centres (ASC). It will be provided for
television receivers only with a screen side of 67cms
or above (product includes CRT, LCDTV, PTV, and
PlasmaTV).Televisions with screen side less than
67cms and all other products types are to be taken or
sent by the consumer to the workshop of your
nearest Authorised Service Centre, at the Consumer’s
expense.
Please record the following information for
your records and keep in a safe place.
We recommend retaining your purchase
receipt to assist with any warranty claim.
Model number:....................................................
Serial number:....................................................
Date of purchase:....................................................
Retailer:....................................................
5. This ManufacturersWarranty is limited to 3 months
for the above listed Consumer Electronics products if
used in commercial applications.
Philips Consumer Electronics
6. Philips may, at its discretion choose to replace rather
a division of Philips ElectronicsAustralia Limited
ABN 24 008 445 743,
than repair any product covered by this warranty.
7. Product accessories are covered by the same
warranty period. Please contact the PhilipsTechnology
Care Centre for free replacement of faulty accessories.
Level 1, 65 Epping Road NORTH RYDE NSW 2113.
Warranty valid for all new products purchased after 1st January 2007
SAFETY & MAINTENANCE INFORMATION
•
Install the unit near the AC outlet and where the AC power plug can be easily
reached.
•
•
The apparatus shall not be exposed to dripping or splashing.
If you do not intend to use the set for a long time, withdraw the mains plug
from the wall socket. In addition to this, it is advisable to remove the battery
from the clock radio. This will prevent any danger of leakage and the clock
radio will not be damaged.
•
•
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
To clean the set, use a soft, slightly dampened chamois leather. Do not use
any cleaning agents containing alcohol, ammonia, benzene or abrasives as
these may harm the housing.
ENVIRONMENTAL INFORMATION
All unnecessary packaging material has been omitted. The packaging can be easily
separated into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled
by a specialized company. Please observe the local regulations regard-
ing the disposal of packaging, dead batteries and old equipment.
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
Problem
–
•
Possible Cause
Remedy
No sound/power
–
•
Volume not adjusted
Adjust the volume
Occasional crackling sound during FM broadcast
–
•
Weak signal
Extend and position the pigtail
Continuous crackling/hiss disturbance during MW (AM/LW) broadcast
–
•
Electrical interference from TV, computer, fluorescent lamp, etc.
Move set away from other electrical equipment
The alarm does not function
–
•
Alarm time not set and/or alarm mode not selected
See the alarm time and / select alarm mode
–
•
Volume too low for RADIO
Adjust the volume
–
•
Radio alarm not adjusted to radio station
Tune to a radio station
NEW ZEALAND - Guarantee and Service for New Zealand
Thank-you for purchasing this quality Philips product.
Philips New Zealand Ltd guarantees this product against defective components and faulty
workmanship for a period of 12 months. Any defect in materials or workmanship occurring
within 12 months from the date of purchase subject to the following conditions will be rectified
free of charge by the retailer from whom this product was purchased.
Conditions
1. The product must have been purchased in New Zealand.As proof of purchase, retain the
original sales docket indicating the date of purchase.
2. The guarantee applies only to faults caused by defective components, or faulty workmanship
on the part of the manufacturer.
3. The guarantee does not cover failures caused by misuse, neglect, normal wear and tear,
accidental breakage, use onthe incorrect voltage, use contrary to operating instructions,
or unauthorised modification to the product or repair by an unauthorised technician.
4. Reasonable evidence (in the form of a sales docket) must be supplied to indicate that the
product was purchased no more than 12 months prior to the date of your claim.
5. In the event of a failure, Philips shall be under no liability for any injury, or any loss or
damage caused to property or products other than the product under guarantee.
This guarantee does not prejudice your rights under common law and statute,
and is in addition to the normal responsibilities of the retailer and Philips.
How to claim
Should your Philips product fail within the guarantee period, please return it to the
retailer from whom it was purchased. In most cases the retailer will be able to
satisfactorily repair or replace the product.
However, should the retailer not be able to conclude the matter satisfactorily, or if you
have other difficulties claiming under this guarantee, please contact
The Guarantee Controller
Philips New Zealand Ltd.
4P.O. Box 41.021
Auckland
3
(09) 84 94 160
fax 3 (09) 84 97 858
AJ 3225 - Clock radio
Meet Philips at the Internet
Printed in China
PDCC-0652
|