•
Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
1 Important
Warning
Safety
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical equipment.
• Keep this apparatus away from direct sunlight, naked
flames or heat.
• Make sure that you always have easy access to the
power cord, plug, or adaptor to disconnect the
apparatus from the power.
Important Safety Instructions
•
•
•
•
•
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
•
•
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
Only use attachments/accessories specified
by the manufacturer.
•
•
Unplug this apparatus during lightning
storms or when unused for long periods
of time.
•
Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
•
•
Apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
apparatus (e.g. liquid filled objects, lighted
candles).
2
EN
Notice
Any changes or modifications made to this
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
The making of unauthorized copies of copy-
protected material, including computer
programs, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.
This product complies with the radio
interference requirements of the European
Community.
“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been
designed to connect specifically to iPod or
iPhone respectively, and has been certified by
the developer to meet Apple performance
standards.Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
the use of this accessory with iPod or iPhone
may affect wireless performance.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product is
covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate
collection system for electrical and electronic products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Note
• The type plate is located on the bottom of the apparatus.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
EN
3
2 Your Docking
Speaker
Overview of the main unit
Congratulations on your purchase, and
welcome to Philips!To fully benefit from the
support that Philips offers, register your product
a
b
c
e
f g h
d
Introduction
a iPod/iPhone dock
b
With this docking speaker, you can enjoy audio
from the iPod/iPhone and other audio devices.
•
Adjust the brightness of bottom light.
c
/
•
Adjust volume.
What's in the box
d Display
e
Check and identify the contents of your
package:
•
Charge your iPod/iPhone through USB
cable.
•
•
•
Main unit
1 x AC adaptor
Quick start guide
f Power supply socket
connect AC power.
•
g CLOCK
•
Adjust the brightness of Display.
h Bottom light
4
EN
3 Get started
Caution
• Use of controls,adjustments,or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus.The
model number and serial number are on the
bottom of the apparatus.Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Turn on
In standby mode, the docking speaker turns on
automatically when it detects an audio signal
from docked iPod/iPhone.
Connect power
Caution
Switch to standby mode
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the unit.
• Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
The unit switches to standby mode if there is
no audio signal from docked iPod/iPhone over
15 minutes.
• Before connecting the AC adaptor, Make sure that you
have completed all other connections.
Connect the AC power adaptor to:
•
the power supply socket on the back of
the docking speaker.
•
the wall power outlet.
EN
5
Load the iPod/iPhone
4 Play
•
Insert your iPod/iPhone into the dock.
» The docking speaker synchronizes the
time from the docked iPod/iPhone.
Play from iPod/iPhone
You can enjoy audio from iPod/iPhone through
this docking speaker.
Compatible iPod/iPhone
The docking speaker supports the following
iPod/iPhone models.
Made for :
•
•
•
•
•
•
•
iPhone 4S
iPhone 4
iPhone 3GS
iPhone 3G
iPhone
iPod classic
iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th
generation)
To remove the iPod/iPhone
Pull your iPod/iPhone out of the dock.
•
•
•
iPod touch(1st, 2nd, 3rd, and 4th
generation)
iPod mini
Listen to the iPod/iPhone
Note
• Make sure that the iPod/iPhone is loaded correctly.
•
Start music play in your iPod/iPhone.
» You can hear music from this docking
speaker.
6
EN
Charge the iPod/iPhone
5 Product
information
When the docking speaker is connected to wall
power outlet, the docked iPod/iPhone begins
to charge.
•
Your can also connect your iPod/iPhone to the
USB socket in the docking speaker to charge.
Note
• Product information is subject to change without prior
notice.
Specifications
Amplifier
Rated Output Power
Signal to Noise Ratio
2X2 W RMS
77 dB
General information
AC power
(power adaptor)
S018KV0590240
(Philips)
Input: 100-240V,
50/60Hz, 500mA;
Output:5.9V 2400mA;
Adjust volume level
Operation Power
Consumption
Dimensions - Main
Unit (W x H x D)
Weight - Main Unit
18W
•
During play, press VOL +/- to increase or
decrease the volume level.
176.4 x 176.4 x77.3mm
0.88 kg
» The volume level shows in the display.
Adjust brightness
•
Press CLOCK repeatedly to select
different levels of display brightness.
•
Press
repeatedly to select different
levels of bottom light brightness.
EN
7
6 Troubleshooting
Warning
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome).When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•
Make sure that the AC power plug of the
unit is connected properly.
•
Make sure that there is power at the AC outlet.
No sound
•
Adjust the volume.
No response from the unit
•
Disconnect and reconnect the AC power
plug, then turn on the docking speaker again.
8
EN
Specifications are subject to change without notice
© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
DS1150_12_UM_V2.0
|