MCD 735
Quick Start Guide
BAND
BAND
What’s in the Box?
You should find these items upon opening the box.
Remote control with two
Subwoofer cable
AC power cord
A/V cord (R/W/Y)
AAA batteries
Quick Start Guide
1
User Manual
2
Quick start guide
User manual
FM and AM antennas
Control Cable
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER 2 on the set
for 3 seconds or more to switch to normal standby mode first before proceeding with the
procedures below.
1
In standby mode, press and hold CLOCK on the remote.
2
When the hour digits flash,turn VOLUME-/+ on the system or press VOLUME+/- on the
remote to set the hours.
3
Press CLOCK again and the minute digits flash.Then turn VOLUME-/+ on the system or
press VOLUME+/- on the remote to set the minutes.
4
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connectedTV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1)Turn off yourTV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM on the remote to exit the system menu and then DISC and“1”
to exit progressive scan.
DIVX(R) VOD
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
Playing a disc
1
Press OPEN •CLOSE (ç on the remote) to open the disc tray and load in a disc, then
press the same button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
2
Playback will start automatically. If not pressÉÅ.
3
To stop playback, press PRESET-/9 (9 on the remote).
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
2
Press PROG on the remote for more than two seconds to program all available stations in
order of waveband.
3
Press PRESET+/- (CH +/- (¡ / ™) on the remote) until the desired preset station is
displayed.
Notes for remote control:
First, select the source you wish to control by
pressing one of the source select keys on the remote
control (DISC orTUNER,for example).
Tip
–
Detailed playback features and
additional functions are described in the
accompany owner's manual.
–
Then select the desired function ( 2;, í, ë for
example).
2005 C Koninklijie Philips Electronics
N.V. All rights reserved.
PDCC-JS/JW-0627
|