Pelco TV Mount PMCL V200 User Manual

C2228M-C (7/07)  
PMCL-V200  
Monitor Mount Adapter  
Important Safety Instructions  
1. Read these instructions.  
2. Keep these instructions.  
3. Heed all warnings.  
4. Follow all instructions.  
5. Installation should be done only by qualified personnel and conform to all local codes.  
6. Use only installation methods and materials capable of supporting four times the maximum specified load.  
7. Only use replacement parts recommended by Pelco.  
8. This unit is designed for indoor use only, and it must not be installed where exposed to rain or moisture.  
Description  
The PMCL-V200 monitor mount adapter allows an LCD monitor mount to be used with larger LCD monitors, such as Pelco’s 500 Series monitors.  
This adapter accommodates monitors with 200 x 200 mm and 200 x 100 mm hole patterns. The PMCL-V200 monitor mount adapter can be used with the  
following Pelco mounts:  
PMCL-WM  
PMCL-WMT  
PMCL-WM1A  
PMCL-WM2A  
PMCL-CM  
Wall mount  
Tilt-swivel wall mount  
Single-arm wall mount  
Double-arm wall mount  
Ceiling mount  
PMCL-CMP  
Ceiling mount and telescoping pole  
Installation  
The following parts are supplied:  
Qty Description  
1
4
4
4
4
4
4
4
Adapter plate  
10-32 x 3/4-inch flat head Phillips screws, stainless steel  
#10 split lock washers  
10-32 hex nuts, stainless steel  
M6 x 12 mm pan head Phillips screws, stainless steel  
#8 split lock washers  
M4 x 10 mm pan head Phillips screws, stainless steel  
Flat washers  
C2228M-C (7/07)  
1
 
PRODUCT WARRANTY AND RETURN INFORMATION  
WARRANTY  
Pelco will repair or replace, without charge, any merchandise proved defective in material or  
workmanship for a period of one year after the date of shipment.  
If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or  
(559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following  
information:  
Exceptions to this warranty are as noted below:  
1. Model and serial number  
Five years on fiber optic products and TW3000 Series unshielded twisted pair transmission  
products.  
2. Date of shipment, P.O. number, Sales Order number, or Pelco invoice number  
3. Details of the defect or problem  
Three years on Spectra® IV products.  
If there is a dispute regarding the warranty of a product which does not fall under the  
warranty conditions stated above, please include a written explanation with the product when  
returned.  
Three years on Genex® Series products (multiplexers, server, and keyboard).  
Three years on Camclosure® and fixed camera models, except the CC3701H-2,  
CC3701H-2X, CC3751H-2, CC3651H-2X, MC3651H-2, and MC3651H-2X camera models,  
which have a five-year warranty.  
Method of return shipment shall be the same or equal to the method by which the item was  
received by Pelco.  
Three years on PMCL200/300/400 Series LCD monitors.  
Two years on standard motorized or fixed focal length lenses.  
Two years on Legacy®, CM6700/CM6800/CM9700 Series matrix, and DF5/DF8 Series fixed  
dome products.  
Two years on Spectra III, Esprit®, ExSite®, and PS20 scanners, including when used in  
continuous motion applications.  
RETURNS  
In order to expedite parts returned to the factory for repair or credit, please call the factory at  
(800) 289-9100 or (559) 292-1981 to obtain an authorization number (CA number if returned for  
credit, and RA number if returned for repair).  
Two years on Esprit and WW5700 Series window wiper (excluding wiper blades).  
All merchandise returned for credit may be subject to a 20% restocking and refurbishing  
charge.  
Two years (except lamp and color wheel) on Digital Light Processing (DLP®) displays.  
The lamp and color wheel will be covered for a period of 90 days. The air filter is not  
covered under warranty.  
Goods returned for repair or credit should be clearly identified with the assigned CA or RA  
number and freight should be prepaid. Ship to the appropriate address below.  
Eighteen months on DX Series digital video recorders, NVR300 Series network video  
recorders, and EnduraSeries distributed network-based video products.  
If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to:  
One year (except video heads) on video cassette recorders (VCRs). Video heads will be  
covered for a period of six months.  
Service Department  
Pelco  
3500 Pelco Way  
Clovis, CA 93612-5699  
Six months on all pan and tilts, scanners or preset lenses used in continuous motion  
applications (that is, preset scan, tour and auto scan modes).  
Pelco will warrant all replacement parts and repairs for 90 days from the date of Pelco  
shipment. All goods requiring warranty repair shall be sent freight prepaid to Pelco, Clovis,  
California. Repairs made necessary by reason of misuse, alteration, normal wear, or accident  
are not covered under this warranty.  
If you are located outside the continental U.S., Alaska, Hawaii or Puerto Rico and are instructed  
to return goods to the USA, you may do one of the following:  
If the goods are to be sent by a COURIER SERVICE, send the goods to:  
Pelco  
Pelco assumes no risk and shall be subject to no liability for damages or loss resulting from  
the specific use or application made of the Products. Pelco’s liability for any claim, whether  
based on breach of contract, negligence, infringement of any rights of any party or product lia-  
bility, relating to the Products shall not exceed the price paid by the Dealer to Pelco for such  
Products. In no event will Pelco be liable for any special, incidental or consequential damages  
(including loss of use, loss of profit and claims of third parties) however caused, whether by  
the negligence of Pelco or otherwise.  
3500 Pelco Way  
Clovis, CA 93612-5699 USA  
If the goods are to be sent by a FREIGHT FORWARDER, send the goods to:  
Pelco c/o Expeditors  
473 Eccles Avenue  
South San Francisco, CA 94080 USA  
Phone: 650-737-1700  
Fax: 650-737-0933  
The above warranty provides the Dealer with specific legal rights. The Dealer may also have  
additional rights, which are subject to variation from state to state.  
The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.  
REVISION HISTORY  
Manual #  
C2228M  
Date  
8/06  
Comments  
Original version.  
C2228M-A  
C2228M-B  
C2228M-C  
10/06  
12/06  
7/07  
Updated supplied hardware per ECO 06-16922.  
Added hardware information for large monitors per ECO 06-17078.  
Added flat washers to Figure 1, and revised the screw size and split lock washers in the parts list and Figure 2.  
Pelco, the Pelco logo, Camclosure, Esprit, ExSite, Genex, Legacy, and Spectra are registered trademarks of Pelco.  
Endura and Spectra III are trademarks of Pelco.  
© Copyright 2007, Pelco. All rights reserved.  
DLP is a registered trademark of Texas Instruments, Inc.  
 
Worldwide Headquarters  
3500 Pelco Way  
Clovis, California 93612 USA  
USA & Canada  
Tel: 800/289-9100  
Fax: 800/289-9150  
International  
Tel: 1-559/292-1981  
Fax: 1-559/348-1120  
ISO9001  
Australia Canada Finland France Germany Italy Macau The Netherlands Russia Singapore  
|
|
|
|
|
|
|
|
|
South Africa Spain Sweden United Arab Emirates United Kingdom United States  
|
|
|
|
|
 

Pelco Home Security System C1043M A User Manual
Philips Battery Charger LR6PS16C User Manual
Philips CD Player SC28L91 User Manual
Philips Universal Remote PS1956C1 User Manual
Philips Universal Remote SRU5107WM 17 User Manual
Pioneer Stereo System VSX 520 K User Manual
Planet Technology Telephone VIP 150T User Manual
Polaroid Flat Panel Television FLU 1514SA User Manual
Poulan Snow Blower 414643 User Manual
Precor Treadmill 905e User Manual