C350SM (10/99)
PS7 and PS7-24
Light-Duty Scanners
This maintenance/service manual consists of an exploded assembly diagram, wiring diagrams,
and parts lists. Use this manual when ordering replacement parts for PS7/PS7-24 Scanners.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
MAINTENANCE
In North America & Canada:
Tel (800) 289-9100
Under normal operating conditions and usage, maintenance of this equipment is not necessary.
The scanners in the PS7 Series require no lubrication, and the motors are both clutch and im-
pedance protected from overload. The outside of the scanner may be cleaned by wiping with a
dry cloth or spraying with clean air pressure. Do not use spray cleaners or water.
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
PS7 and PS7-24 Parts List
Item
Qty
Description
Part Number
1
2
3
4
5
6
7
2
2
1
2
1
1
1
Pan limit stop
58010006
Clutch
PS710000
Drag clutch
PS710002
Limit friction disk
Switch actuator
Switch bracket
PC board assembly
120 VAC (model PS7)
24 VAC (model PS7-24)
Switch
PS710001
PS74015COMP
PS74016COMP
PS71004COMP
PS71003COMP
SWI11-314
8
1
1
1
1
1
1
1
4
1
1
1
1
1
2
1
1
1
9
Rubber grommet
Bottom plate
Top plate
GRO2170
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
PS74100COMP
PS74101COMP
PS74002
Body
Limit support
Mounting plate
Spacer
PS74003COMP
PS74004COMP
ZH30-0202-0404
PS74009COMP
PS74011COMP
PS74012COMP
PS74134COMP
PS76000
Pressure plate
Thrust collar
Bearing holder
Tilt table
Bearing
Washer
PS76001
Spring
PS76002
Spring
PS76003
Motor
120 VAC (PS7)
24 VAC (PS7-24)
Spacer, threaded 6-32 x 2.50 round
2708000
PS78001
SPA1857
25
2
A
B
C
D
E
F
G
H
I
1
Nut, 10-32
ZH10-32NUTSH
ZH10-32X.312S
ZH10-32X.375SPP
ZH10-32X.500SPP
ZH10-32X1.00SFP
ZH10LWSIS
3
Set screw, 10-32 x .3125-inch
5
Screw, 10-32 x .375-inch, Phillips, pan head
Screw, 10-32 x .5-inch, Phillips, pan head
Screw, 10-32 x 1-inch, Phillips, flat head
Internal tooth lock washer, #10
1
2
7
2
Screw, 2-56 x .75-inch, Phillips, pan head
Set screw, 6-32 x .1875-inch
ZH2-56X.750SRS
ZH6-32X.187S
2
6
Screw, 6-32 x .375-inch slot, flat head
Screw, 6-32 x .375-inch, Phillips, pan head
Internal tooth lock washer, #6 (not shown)
ZH6-32X.375SFP
ZH6-32X.375SPP
ZH6LWSIS
J
6
L
2
Not used
2
M
N
Screw, 10-32 x .75-inch Phillips, flat head
ZH10-32X.750SFP
WIRING DIAGRAMS
PS7 WIRING DIAGRAM
PS7-24 WIRING DIAGRAM
WARRANTY AND RETURN INFORMATION
WARRANTY
If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or
(559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following
information:
Pelco will repair or replace, without charge, any merchandise proved defective in material
or workmanship for a period of one year after the date of shipment.
Exceptions to this warranty are as noted below:
1. Model and serial number
2. Date of shipment, P.O. number, Sales Order number, or Pelco invoice number
3. Details of the defect or problem
• Five years on FT/FR8000 Series fiber optic products.
• Three years on Genex® Series products (multiplexers, server, and keyboard).
• Three years on Camclosure® and fixed camera models, except the CC3701H-2,
CC3701H-2X, CC3751H-2, CC3651H-2X, MC3651H-2, and MC3651H-2X camera
models, which have a five-year warranty.
If there is a dispute regarding the warranty of a product which does not fall under the
warranty conditions stated above, please include a written explanation with the product
when returned.
• Two years on standard motorized or fixed focal length lenses.
• Two years on Legacy®, CM6700/CM6800/CM9700 Series matrix, and DF5/DF8 Series
fixed dome products.
Method of return shipment shall be the same or equal to the method by which the item
was received by Pelco.
RETURNS
• Two years on Spectra®, Esprit®, ExSite™, and PS20 scanners, including when used in
continuous motion applications.
In order to expedite parts returned to the factory for repair or credit, please call the factory
at (800) 289-9100 or (559) 292-1981 to obtain an authorization number (CA number if
returned for credit, and RA number if returned for repair).
All merchandise returned for credit may be subject to a 20% restocking and refurbishing
charge.
• Two years on Esprit® and WW5700 Series window wiper (excluding wiper blades).
• Eighteen months on DX Series digital video recorders, NVR300 Series network video
recorders, and Endura™ Series distributed network-based video products.months on DX
Series digital video recorders, NVR300 Series network video recorders, Endura™ Series
distributed network-based video products, and TW3000 Series twisted pair transmission
products.
Goods returned for repair or credit should be clearly identified with the assigned CA or RA
number and freight should be prepaid. Ship to the appropriate address below.
If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods
to:
• One year (except video heads) on video cassette recorders (VCRs). Video heads will be
covered for a period of six months.
Service Department
Pelco
• Six months on all pan and tilts, scanners or preset lenses used in continuous motion
applications (that is, preset scan, tour and auto scan modes).
3500 Pelco Way
Clovis, CA 93612-5699
Pelco will warrant all replacement parts and repairs for 90 days from the date of Pelco
shipment. All goods requiring warranty repair shall be sent freight prepaid to Pelco, Clovis,
California. Repairs made necessary by reason of misuse, alteration, normal wear, or
accident are not covered under this warranty.
If you are located outside the continental U.S., Alaska, Hawaii or Puerto Rico and are
instructed to return goods to the USA, you may do one of the following:
If the goods are to be sent by a COURIER SERVICE, send the goods to:
Pelco assumes no risk and shall be subject to no liability for damages or loss resulting
from the specific use or application made of the Products. Pelco’s liability for any claim,
whether based on breach of contract, negligence, infringement of any rights of any party
or product liability, relating to the Products shall not exceed the price paid by the Dealer to
Pelco for such Products. In no event will Pelco be liable for any special, incidental or
consequential damages (including loss of use, loss of profit and claims of third parties)
however caused, whether by the negligence of Pelco or otherwise.
Pelco
3500 Pelco Way
Clovis, CA 93612-5699 USA
If the goods are to be sent by a FREIGHT FORWARDER, send the goods to:
Pelco c/o Expeditors
473 Eccles Avenue
South San Francisco, CA 94080 USA
Phone: 650-737-1700
Fax: 650-737-0933
The above warranty provides the Dealer with specific legal rights. The Dealer may also
have additional rights, which are subject to variation from state to state.
REVISION HISTORY
Manual # Date
C350SM 10/99
Comments
Original version.
® Pelco, the Pelco logo, Spectra, Esprit, Genex, Legacy, and Camclosure are registered trademarks of Pelco.
™ Endura and ExSite are trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved.
|