10.2 TFT LCD COLOR MONITOR/DVD
Instruction Manual
WWW.PYLEAUDIO.COM
WARNING:
HAZARD DO NOT OPERATE THIS
UNIT UNLESS VEHICLE ISPARKED
IN SAFE ANDLEGAL AREA
PLRD102
Attachment
1.maintain of DVD MONITOR
please use normally rotund disc. If you put in an abnormity, not rotund
disc, they will be locked by the player or can not play well.
Make sure the disc before play has no split, scratch or warp.
Do not touch the record surface ( not printed side)
Keep disc in the disc pack after playing;
Do not expose disc under direct sunlight or high temperature;
Do not stick label, write or use chemical on the surface of disc;
If you use central heating in cold weather, you may find dews on the DVD
player, which may make the unit can not work well. Then please cut off
the unit for 1 hour to make it dry and wipe the disc by dry cloth.
Shock may cause the play stop.
‰
Š
2.MAINTAIN OF DISC
A: some functions may not available for certain kinds of DISCS.
B: some discs may not compatible with this unit.
C: this unit can only play DVD-R/DVD-RW disc in video mode, and some
files download from computer can not be read.
D: broken, dirty or wet disc can not be read.
‡
ˆ
E: some disc recorded by personal may can not be read for the format
of recording.
F: when play MP3 format , adopt special method to playing, because of
the special MP3 format of document storage.
†
G: should use
to choose the file when play MP3 disc,
closed by ENTER.
3.MAINTAIN OF REMOTE CONTROL
A: Do not expose it in direct sunlight or put in on the instrument board
B: Especially in summer, the high temperature there will make it distorted
C: the unit may can not receive the signal from the remote control
under direct sunlight, move it near to the unit
…
• ‚ ƒ „
1)Power ( control display)
2) -
5) IR TRANSMIT
7) FIX PEDESTAL
9) LEFT LAMP
11) EJECT
3) MENU
4) +
6) LCD MONITOR
8) LAMP BUTTON
10) RIGHT LAMP
12) PLAY/PAUSE
13) BACKWARD
15) STOP
14)FAST FORWARD
16) DVD INDICATOR
17) OPEN
2
13
BASIC TROUBLE SHOOTING
Installation
Fault
reason
resolvent
connect power
correctly
red wire goes to 12v +;
black one goes to ground
No power
change fuse
Fuse Blowout
connect correctly
to the power
Power line unconnected
no VD input
input video
reset dvd
No picture
No dvd signals output
connect video lineagain
Video lines unconnected
take out the paper
battery protection
paper unload
aim at the receiver
window
Remote
useless
Aim at wrong direction
change battery
No power
bad disc
Can not play
Distortion
change better disc
re-put disc
disc load in mistake way
Disc dirty
clean disc
Normally
Fast forward/ backward
3.INSTALLATION
Use the 6 pieces of machine screws(4x20BA) , and fix the setting plate to
the place, then assembly the unit of monitor to the setting plate.
12
3
REMOTE CONTROL FUNCTIONS
1.PDVD: DVD power
WIRING DIAGRAM
2.DISPLAY: show information about disc
3.PBC: when it plays super VCD, VCD2.0, it can
show menu of the song: song 1, song 2,--- choose
number directly.
4.RESUME: memorial play
5. Inhale / eject disc
L/R
AUDIO
STEP
6.GOTO: set time
MUNE
7.L/R: right / left channel
8.PRO-GRAM: edit
9.PLAY/PAUSE: press once, it plays or stops play;
press again , it returns.
RETURN
10.STOP: stop play if press this button
11.1~10: number
12.AUDIO: mode of audio
13.STEP: press this button, it will play next picture;
press PLAY, it comes to normally mode.
14.TITLE: back to main page
15.MENU:menu
U/L
POWER
16.
Next song
FILTER
17.
18.
19.
Last song
fast forward
Fast backward
20.A-B: repeat play start part A to part B by press this button two times
( first press is A and the second is B), press third time, it stops repeat play.
21.RETURN: back to main menu
22.ENTER: confirm
BATTERY
CAR AUDIO(DVD OR VCD)
Wiring diagram
23.
: direction
24.SLOW: play slowly
25.ZOOM: zoom the picture with 4 class
26.SETUP: set
27.REPEAT: repeat play
28.VOL-: lower
29.VOL+: louder
30.ANGLE: video angle
31.SUBTITLE
32.MUTE
33.AV
Step 1 : please take out power signal cable from attached bag, long
cable connect the thrum ,as per arrow direction, with screen
signal thrum insert it correctly
Step 2: connect the power correctly, red cable is anode , black cable
is cathode
Setp 3: signal cable ( 1 way) is video input,one of red cable and white cable
are left and right audio input, others are left and right output.
( please see the tag )
34.U/L: display start up or down way
35.-: reduce
36.SEL: menu
37.+: increase
38.POWER: power of this monitor
11
4
FUNCTIONS
AUDIO SETUP
FULL
AUDIO SETUP
1)Brightness
AUDIO OUT
DOWN MIX
AUDIO OUT
DOWN MIX
LT/RT
STEREO
Enter into MENU, use + - buttons to adjust the picture s brightness,
can adjust the range in 0~100. attached is the main menu.
6/8
4/8
2/8
DYNAMIC RANGE
DOWN SAMPLE
DYNAMIC RANGE VSS
DOWN SAMPLE
OFF
NTSC
Brightness
N720x240
OFF
EXIT SETUP
EXIT SETUP
Contrast
Hue
Saturation
Language
Volume
Exit
AUDIO SETUP
AUDIO SETUP
AUDIO OUT
DOWN MIX
DYNAMIC RANGE
AUDIO OUT
DOWN MIX
DYNAMIC RANGE
DOWN SAMPLE
Select
2) Contrast
Enter into MENU, use
contrast . Can adjust the range in 0~100.attached is the main menu.
DOWN SAMPLE
48K
96K
192K
+
-
buttons to adjust the picture s
EXIT SETUP
EXIT SETUP
NTSC
Brightness
N720x240
NOTICE:
A: Should use
to set and ENTER to confirm your set.
Contrast
Hue
Saturation
Language
Volume
Exit
B: do not change preset if unnecessary
C: if this set compatible with PALand NTSC, it would be better
choose NTSC
D: Original password is 0000
E: part of the functions are available only under certain condition,
while some are not available right now.
Select
3) Hue
Enter into MENU, use
can adjust the range in 0~100. this function apply to the NTSC system
only . normally, adjust the range of hug in 50.attached is the main menu.
+
-
buttons to adjust the picture s hue.
Playing edit
if there are two tiles or songs above in the disc, use PRO-GRAM
button to set the order, it will show 1[--],2[--]---on the picture, so
press the number to edit the order, then you can use and
ENTER to play.
NTSC
Brightness
N720x240
Contrast
Hue
Saturation
Language
Volume
Exit
Select
5
10
B: language setting
4)saturation
Press SETUP to set up the language , attached is the main menu and sub menu:
Enter into MENU, use + - buttons to adjust the picture s saturation.
can adjust the range in 0~100.attached is the main menu.
LANGUAGE SETUP
LANGUAGE SETUP
NTSC
Brightness
N720x240
OSD LANGUAGE
AUDIO LANG
SUBTITLE LANG
MENU LANG
OSD LANGUAGE
AUDIO LANG
SUBTITLE LANG
MENU LANG
ENGLISH
CHINESE
GERMAN
SPANISH
FRENCH
PORTUGUESE
ITALIAN
Saturation
Contrast
Hue
Saturation
Language
Volume
Exit
-
+ 50
EXIT SETUP
EXIT SETUP
Exit
JAPAN
Select
LANGUAGGE SETUP
LANGUAGE SETUP
5)Language
OSD LANGUAGE
AUDIO LANG
SUBTITTLE LANG
MENU LANG
CHINESE
ENGLISH
JAPAN
FRENCH
SPANISH
PORTUGUESE
GERMAN
OFF
OSD LANGUAGE CHINESE
Enter into MENU, use + - buttons to adjust the picture s language.
Can adjust the range in 0---100.attached is the main menu.
AUDIO LANG
SUBTITLE LANG
MENU LANG
ENGLISH
JAPAN
FRENCH
SPANISH
PORTUGUESE
LATIN
EXIT SETUP
EXIT SETUP
Language
NTSC
Brightness
N720x240
GERMAN
English
Deutsch
Franis
Espanol
I tal iano
Slimplified Chinese
Traditional Chinese
Contrast
Hue
Saturation
Language
Volume
Exit
LANGUAGE SETUP
LANGUAGE SETUP
OSD LANGUAGE CHINESE
OSD LANGUAGE
AUDIO LANG
SUBTITLE LANG
AUDIO LANG
SUBTITLE LANG
MENU LANG
ENGLISH
JAPAN
FRENCH
SPANISH
PORTUGUESE
GERMAN
LATIN
Select
MENU LANG
EXIT SETUP
EXIT SETUP
6)Volume
N/A
C: audio setting
NTSC
Brightness
N720x240
Press SETUP to set up the audio, attached is the main menu and sub menu:
Volume
Contrast
Hue
AUDIO SETUP
+ 50
Saturation
Language
Volume
Exit
AUDIO OUT
DOWN MIX
DYNAMIC RANGE
DOWN SAMPLE
AUDIO OUT
DOWN MIX
DYNAMIC RANGE SPDIF/PCM
DOWN SAMPLE
SPDIF/OFF
SPDIF/RAW
Exit
Select
EXIT
EXIT
9
6
7)Exit
Enter into MENU, use
9) DVD TITLE
Turn to DVD title by press TITLE on the remote control.
10) DVD SETTING
+
-
buttons to adjust the exit
A: normally setting
press SETUP to preset DVD , Attached is the main menu and sub menu.
NTSC
Brightness
N720*240
Contrast
Hue
SYSTEM SETUP
SYSTEM SETUP
Saturation
Language
Volume
Exit
TV SYSTEM
SCREEN SAVER
TV TYPE
PASSWORD
RATING
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
NTSC
PAL 60
PAL
AUTO
Select
DEF AULT
DEF AUL T
DVD FUNCTIONS
EXIT SETUP
EXIT SETUP
1). DVD PLAYER
DVD reading indication light will gleam when loading DVD DISC; and
SYSTEM SETUP
SYSTEM SETUP
then when disc is reading the light turns to be shining.
2) PAUSE
press when playing , it will pause playing for you to see inactive
picture.
Press it again, it will go on playing.
3)STOP
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
1MIN
5MIN
10MIN
30MIN
OFF
4:3PS
4:3LB
16:9
DEF AUL T
DEF AUL T
Press it will stop playing
4)FAST FORWARD / BACKWARD
EXIT SETUP
EXIT SETUP
press
press
5)LAST/NEXT
press
6)TURN TO APPOINTED MENU OR TIME
press GOTO one time, will show following picture:
to fast forward and backward when playing DVD, while
to go on playing.
SYSTEM SETUP
SYSTEM SETUP
to chose last or next song by remote control.
TV SYSTE
SCREEN SAVER
TV TYPE
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
DEF AUL T
- - - -
PASSWORD
RATING
DEF AUL T
NO ADULT
KID SAFE
VIEW ALL
01/02
001/001
00:00:00
Title
Time
EXIT SETUP
EXIT SETUP
present title total title present song total songs
SYSTEM SETUP
SYSTEM SETUP
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
press
on the remote control to present song, then input the number
TV SYSTE
SCREEN SAVER
TV TYPE
PASSWORD
RATING
of the song or the time you want closed by ENTER, If the number is 10
above, press 10 and then the number.
7)DVD INFO
Press
8)DVD player menu
DISPLAY on the remote control to display DVD information .
DEF AUL T
RESTORE
DEF AUL T
Press
MENU on the remote control to turn into DVD menu, as per
EXIT SETUP
EXIT SETUP
8
play menu, enter into number to choice the program.
7
|