PVI Industries Water Heater PV 6323 User Manual

SPECIFICATION FOR DOMESTIC WATER HEATERS  
Condensing , Low NOx, Gas-Fired Water Heaters with Polymer-Lined Storage Tanks  
Furnish and install POWER VT condensing gas water heater(s) as manufactured by PVI Industries, LLC  
of Fort Worth, Texas. Supply in quantities and model numbers as indicated on the plumbing schedule.  
Emissions  
NOx emissions will not exceed 30 ppm when corrected to 3% O2 (for inputs greater than 399,000 Btu).  
NOx emissions will not exceed 55 ppm when corrected to 3% O2 (for 399,000 Btu input). These levels will be  
certified by independent agency.  
Gas and Electrical Consumption  
The water heater will operate at a minimum of 94% thermal efficiency when tested to ANSI Z21.10.3. The water  
heater will comply with paragraph 7.2.4.4, the thermal efficiency, the standby loss, and all other requirements of  
ASHRAE 90.1-1999.  
Pressure Vessel and Heating Surfaces  
The water heater will be a vertical fire tube design that is constructed and stamped in accordance with Section IV,  
Part HLW of the ASME code. Both the storage and heating sections of the water heater will be National Board  
Registered for a working pressure of 150 psi and will be pressure tested at 1-1/2 times working pressure. The fireside of  
the heating surfaces will be of boiler-grade steel. The waterside of the heating tubes will be sealed in copper. The  
heating tubes will be rolled, beaded, and seal welded into the tube sheets. The combustion side of the tube sheet will be  
insulated by a layer of ceramic fiber that will protect the tube sheet from both thermal stresses and failure that can result  
from the accumulation of scale and precipitants.  
Lining  
The lining will:  
be applied only after the tank is completely fabricated and all welding is completed.  
consist of multiple applications of a high-temperature fluoropolymer.  
be third-party tested to and comply with NSF 61 standard.  
be continuous and nonporous with no interruptions or discontinuities.  
require no sacrificial anode rods for protection.  
Burner and Venting  
Combustion will be provided by an induced-draft power burner with a gas train meeting the following agency  
requirement for the input specified:  
___ UL (standard)  
___ FM  
___ IRI  
___ Other ______________________  
Water heater will be a category IV, condensing appliance, UL listed for use with CPVC vent or AL 29-4C stainless  
steel vent. Burner will be configured to accept ____ room air _____ direct inlet combustion air. Water heater will operate  
with a minimum gas pressure of 4 ½ inches water column.  
(continued)  
PV 6323 4/04  
1
 

Peavey Music Mixer 880FX User Manual
Pelco Paint Sprayer EH2200 User Manual
Pelco Security Camera C1463SM User Manual
Philips CRT Television TP3669C User Manual
Philips Stereo Receiver MX 1050D User Manual
Philips Stereo Receiver SBC RU 430 User Manual
Philips TV Cables SWA2437W User Manual
Pinnacle Design TV Video Accessories TV51101 User Manual
Poulan Tiller 156335 User Manual
Presonus Audio electronic Stereo Amplifier D8 User Manual