Patton electronic Security Camera 07MSNBX QS User Manual

SmartNode™ Branch eXchange Series  
SIP 3CX Based Private  
Branch Exchange  
Quick Start Guide  
ImportantThis is a Class B device and is intended for use in a light industrial  
or residential environment. It is not intended nor approved for use in an  
industrial environment.  
Part Number: 07MSNBX-QS, Rev. B  
Revised: June 25, 2014  
Sales Office: +1 (301) 975-1000  
Technical Support: +1 (301) 975-1007  
 
1.0 Before you begin  
In the box, you will find:  
One SmartNode Branch eXchange (SNBX)  
One External Power Supply  
One RJ45 Ethernet Straight Cable (male-to-male)  
One warranty sheet  
One packing slip  
One SmartNode Branch eXchange Quick Start Guide  
To install the SNBX, you will need (not included):  
KVM, keyboard, and mouse  
or  
One External PC  
2.0 Connecting to the Power Source  
1. Connect the external power supply to the SNBX by inserting the barrel connector  
into the DC-IN port, and connect the power adapter to mains power.  
2. Verify that the Power button on the front panel is lit (solid green). If the power  
button is not lit, press the Power button on the front of the SNBX.  
3.0 Connecting the SNBX via KVM  
1. Plug a keyboard and mouse into the USB ports on the front panel of the SNBX.  
2. Connect a video monitor display into the port labeled DVI/VGA on the rear panel  
of the SNBX.  
SmartNode Branch eXchange Quick Start Guide  
3
 
 
4.0 Installing the SNBX via a Remote Host  
1. Connect using the Microsoft Terminal Server Connection (MSTSC) (Remote  
Desktop Connection-RDP) to IP Address 192.168.200.10/24.  
2. Connect directly to the 3CX Server as described in section 5.1 “Connecting the  
5.0 Connecting to the Windows host  
1. Connect to the Windows host through the console (KVM) (see 3.0 “Connecting  
the SNBX via KVM” on page 3) OR through remote means (see 4.0 “Installing  
the SNBX via a Remote Host” on page 4). The IP address of the management  
port is set to 192.168.200.10/24 with a default route to 192.168.200.1.  
2. The default HOSTNAME is PATTON-SNBX in a workgroup labeled WORKGROUP.  
3. The Windows Administrator account is patton/patton  
5.1 Connecting the Ethernet management interface  
1. Connect the supplied (or other) CAT5 Ethernet cable to the LAN port on the rear  
panel of the SNBX.  
2. Log into the SmartNode remotely via MSTSC or RDP.  
6.0 Logging into the Web Interface  
This section describes how to login to the SmartNode Branch eXchange (SNBX)  
Web Portal.  
The first step involved in initially configuring any 3CX-based system involves logging  
on to the Web Portal. This can be divided into two distinct tasks: Connecting to the  
SNBX via IP (Refer to 4.0 “Installing the SNBX via a Remote Host” on page 4), and  
log on to the Web Portal.  
6.1 Connecting to the web server  
Using a web browser, connect to the Web Portal by typing the following in your  
browser address bar:  
or, alternately,  
4
SmartNode Branch eXchange Quick Start Guide  
 
   
Note The default IP address of the SNBX is 192.168.200.10/24.  
6.2 Logging on to the Web Portal  
In order to log on to the Web Portal/3CX Management, enter the default user ID and  
password:  
User ID: admin  
Default password: admin  
7.0 Additional Information  
Refer to the following document for detailed information about installing, configuring,  
and operating the SNBX models, along with warranty, trademark, and compliance infor-  
mation.  
Note Contact Patton Tech Support below for questions or concerns installing,  
configuring, or troubleshooting the Patton SmartNode Branch  
eXchange device.  
A.0 Customer and Technical Support  
Toll-Free VoIP support: call sip:[email protected] with a VoIP SIP client  
Online support: www.patton.com  
E-mail support: [email protected]—answered within 1 business day  
Telephone support:  
Standard: +1 (301) 975-1007 (USA), Monday–Friday: 8:00 am to 5:00 pm EST  
(1300 to 2200 UTC/GMT)  
Alternate: +41 (0)31 985 25 55 (Switzerland), Monday–Friday: 9:00 am to 5:30 pm  
CET (08:00 to 16:30 UTC/GMT)  
Fax: +1 (253) 663-5693 (USA) or +41 (0)31 985 25 26 (Switzerland)  
SmartNode Branch eXchange Quick Start Guide  
5
 
B.0 Compliance Information  
B.1 Compliance  
EMC Directive:  
FCC Part 15, Class B  
EN55022, Class B  
EN55024  
Low-Voltage Directive (Safety):  
IEC/EN60950-1 2nd Edition  
B.2 CE Declaration of Conformity  
Patton Electronics, Inc declares that this device is in compliance with the essential  
requirements and other relevant provisions of Directive 2004/108/EC relating to elec-  
tromagnetic compatibility, Directive 2006/95/EC relating to electrical equipment  
designed for use within certain voltage limits and Directive 2011/65/EU relating to  
RoHS compliance. The Declaration of Conformity may be obtained from Patton Elec-  
The safety advice in the documentation accompanying this device shall be obeyed. The  
conformity to the above directive is indicated by CE mark on the device.  
B.3 Authorized European Representative  
D R M Green, European Compliance Services Limited.  
Greyfriars Court, Paradise Square, Oxford, OX1 1BE, UK  
B.4 FCC Part 15  
This device generates and uses radio frequency energy, and if not installed and used  
properly-that is, in strict accordance with the manufacturer’s instructions-may cause  
interference to radio and television reception. The device has been tested and found to  
comply with the limits for a Class B computing device in accordance with specifications  
in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protec-  
tion from such interference in a commercial installation. However, there is no guarantee  
that interference will not occur in a particular installation. If the device does cause inter-  
ference to radio or television reception, which can be determined by disconnecting the  
unit, the user is encouraged to try to correct the interference by one or more of the fol-  
lowing measures: moving the computing equipment away from the receiver, re-orient-  
ing the receiving antenna and/or plugging the receiving equipment into a different AC  
outlet (such that the computing equipment and receiver are on different branches).  
6
SmartNode Branch eXchange Quick Start Guide  
 
Copyright © 2013, Patton Electronics Company. All rights reserved.  
The information in this document is subject to change without notice. Patton Electron-  
ics assumes no liability for errors that may appear in this document.  
Trademarks statement  
The term SmartNode is a trademark of Patton Electronics Company. All other trade-  
marks presented in this document are the property of their respective owners.  
Warranty  
For warranty information, please contact Tech Support.  
SmartNode Branch eXchange Quick Start Guide  
7
 
NOTES  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
____________________________________________________________________  
8
SmartNode Branch eXchange Quick Start Guide  
 

Miele Dishwasher G4510 User Manual
Mr Coffee Espresso Maker ECM10 User Manual
NEC Computer Hardware SB L007KK User Manual
Nokia Cell Phone V104 User Manual
NXR Range DRG83602 User Manual
Omnimount TV Mount OM10047 User Manual
Optoma Technology Projector PK 101 User Manual
Panasonic Network Card 2SA2079 User Manual
Parkinson Cowan Cooktop SONATA 50GX User Manual
Patton electronic Surge Protector MODEL 552 User Manual