Panasonic Telephone Accessories KX DT390 User Manual

Quick Reference Guide  
Digital DSS Console  
Model No. KX-DT390  
Thank you for purchasing a Digital DSS Console. Please read this  
manual carefully before using this product and save this manual for  
future use. This manual is designed to be used with your Digital  
DSS Console and a Panasonic PBX.  
The Digital DSS Console can be used with the following Panasonic  
Digital Proprietary Telephones (DPTs): KX-DT333, KX-DT343, and  
KX-DT346.  
The Digital DSS Console must be connected directly to the main  
unit.  
Accessories (included)  
Telephone Line  
Cord: 1  
Plate: 1  
Wall Mounting  
*1  
Adaptor : 1  
Screws for wall: 2  
Screws for plate: 4  
*1  
This telephone comes with the wall mounting adaptor already attached.  
To remove the adaptor, refer to step 1 on page 4.  
Document Version 2009-03  
 
 
Operation Board Angle Adjustment  
To lower:  
Raise the operation board to level 8. Next, with one hand on the  
base of the unit, lift the operation board again to release the latch,  
then slowly push the operation board down to level 1. If the  
operation board cannot be lowered to level 1, repeat this step.  
Attaching a DPT  
1. Fit the protrusions on the  
KX-DT390 and a DPT into the  
4 holes on the plate (included).  
2. Attach the plate with the 4  
screws (included).  
Document Version 2009-03  
 
3
Wall Mounting  
CAUTION:  
Do not mount this unit on a wall while attached to a DPT.  
Doing so may damage the wall mounting adaptor or, may cause  
the unit to fall, possibly resulting personal injury.  
1. Remove the wall mounting  
adaptor from the unit as shown.  
2.Set the operation board to level  
1, then connect and secure the  
telephone line cord.  
3.Attach the wall mounting adaptor  
as shown.  
Make sure the cord is not pinched  
by the wall mounting adaptor.  
When running the cord from the top  
of the unit, look through the  
opening in the wall mounting  
adaptor (A) to confirm that the  
cord is not being pinched.  
4. Drive the 2 screws (included) into  
the wall either 83 mm (3-1/4 in) or  
100 mm (3-15/16 in) apart, and  
83 mm  
(3-1/4 in)  
mount the unit on the wall.  
100 mm  
You can find a wall mounting  
(3-15/16 in)  
template on page 8.  
Make sure that the wall that the unit  
will be attached to is strong enough  
Washer  
to support the unit (approx. 1 kg  
Drive the screw  
to this point.  
[2.2 lb]).  
Make sure the cord is securely  
fastened to the wall.  
When this unit is no longer in use,  
make sure to detach it from the  
wall.  
4
Document Version 2009-03  
 
 
Important Information  
When using a KX-DT390 Digital DSS Console, keep the  
following conditions in mind.  
If you are having problems making calls, unplug the extension line and  
connect a known working Digital DSS Console. If the known working DSS  
Console operates properly, have the defective DSS Console repaired by  
an authorized Panasonic factory service center. If the known working  
DSS Console does not operate properly, check the PBX and the internal  
extension wiring.  
Wipe the unit with a soft cloth. Do not clean the unit with abrasive  
powders or with chemical agents such as benzene or thinner.  
Take special care to follow the safety suggestions listed below.  
Installation  
Environment  
1) Do not use this unit near water, for example, near a bathtub, washbowl  
or sink. Damp basements should also be avoided.  
2) Keep the unit away from heating appliances and devices that generate  
electrical noise, such as fluorescent lamps, motors, and televisions.  
These noise sources can interfere with the performance of the unit. It  
also should not be placed in rooms where the temperature is less than  
5 °C (41 °F) or greater than 40 °C (104 °F).  
Allow 10 cm (3-15/16 in) clearance around the unit for proper  
ventilation.  
Placement  
1) Do not place heavy objects on top of this unit.  
2) Care should be taken so that objects do not fall onto, and liquids are  
not spilled into, the unit. Do not subject this unit to excessive smoke,  
dust, moisture, mechanical vibration, shock, or direct sunlight.  
3) Place the unit on a flat surface.  
WARNING:  
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT  
EXPOSE THIS UNIT TO RAIN OR MOISTURE.  
DISCONNECT THE TELEPHONE LINE CORD FROM THIS PRODUCT IF  
THIS PRODUCT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES  
UNUSUAL NOISE. THESE CONDITIONS CAN CAUSE FIRE OR  
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND  
CONTACT AN AUTHORIZED SERVICE CENTER.  
Document Version 2009-03  
 
5
Important Information  
When you ship the product:  
Carefully pack and send it prepaid, adequately insured and preferably in the  
original carton. Attach a postage-paid letter, detailing the symptom to the  
outside of the carton.  
DO NOT send the product to the Executive or Regional Sales offices. They  
are NOT equipped to make repairs.  
Product service:  
Panasonic factory service centers for this product are listed in the service  
center directory.  
Consult your authorized Panasonic dealer for detailed instructions.  
Important Safety Instructions  
When using this unit, basic safety precautions, including those below,  
should always be followed to reduce the risk of fire, electric shock and injury  
to persons.  
1. Do not use the unit near water, for example, near a bathtub, wash bowl,  
kitchen sink or laundry tub, in a wet basement, or near a swimming pool.  
2. Avoid using a wired telephone during an electrical storm. There is a  
remote risk of electric shock from lightning.  
3. Do not use a telephone in the vicinity of a gas leak to report the leak.  
SAVE THESE INSTRUCTION  
FCC Information  
F.C.C. REQUIREMENTS AND RELEVANT INFORMATION  
This equipment has been tested and found to comply with the limits for a  
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection against harmful interference  
in a residential installation.  
This equipment generates, uses, and can radiate radio frequency energy  
and, if not installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television reception,  
which can be determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of the following  
measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
6
Document Version 2009-03  
 
Important Information  
CAUTION:  
To assure continued compliance with FCC rules, do not make any  
unauthorized changes or modifications to this equipment would void the  
user’s authority to operate this device.  
When programming emergency numbers and/or making test calls to  
emergency numbers:  
1) Remain on the line and briefly explain to the dispatcher the reason for  
the call before hanging up.  
2) Perform such activities in the off peak hours, such as early morning  
hours or late evenings.  
Customer Information  
If trouble is experienced with this equipment KX-DT390, for repair or  
warranty information, please contact:  
Panasonic Service and Technology Company-BTS Center  
415 Horizon Drive Bldg. 300 Ste. 350-B  
Suwanee, GA 30024-3186  
If the equipment is causing harm to the telephone network, the telephone  
company may request that you disconnect the equipment until the problem  
is resolved.  
Document Version 2009-03  
 
7
157 mm (6-1/5 in)  
One screw here  
One screw here  
WALL MOUNTING TEMPLATE  
1. Drive the screws into the wall as indicated.  
Note:  
If the KX-DT390 is mounted beside a  
DPT, leave 157 mm (6-1/5 in) of  
space between the 2 screws for the  
DPT and the 2 screws for the KX-  
DT390, as indicated above. This  
space is abbreviated in this template  
and must be measured.  
2. Hook the unit onto the screw heads.  
Panasonic Consumer Electronics Company,  
Division of Panasonic Corporation of North  
America  
One Panasonic Way Secaucus, New Jersey 07094  
Copyright:  
This material is copyrighted by Panasonic  
Communications Co., Ltd., and may be reproduced for  
internal use only. All other reproduction, in whole or in  
part, is prohibited without the written consent of  
Panasonic Communications Co., Ltd.  
©
Panasonic Communications Co., Ltd. 2009  
One screw at either point  
One screw at either point  
PSQX4707ZA-UU (A) KK0309YH0 (M)  
 
 

Milwaukee Saw HEAVY DUTY CIRCULAR SAW User Manual
NordicTrack Home Gym NTHK99901 User Manual
Omega Vehicle Security Automobile Accessories AS9256 User Manual
Optoma Technology Projector HD81 LV User Manual
Oreck Vacuum Cleaner XL7 605 EYB User Manual
Oricom Baby Monitor SECURE 200 User Manual
Panasonic Air Conditioner CS KS24NKU User Manual
Panasonic MP3 Player EG EB GC GK GN GH En User Manual
Panasonic Vacuum Cleaner MC 4500 User Manual
Paradise Universal Remote RCP2 1000 User Manual