Panasonic Cordless Telephone KX TPA50 User Manual

Installation Manual  
Additional Cordless Handset  
Model No. KX-TPA50  
Contents/Contenu/Contenido  
Page/Page/Página  
1 - 10  
English instructions  
Instructions en français  
Instrucciones en español  
(1) - (10)  
<1> - <7>  
Thank you for purchasing a Panasonic product.  
This unit is an additional handset compatible with the following  
series of Panasonic SIP Cordless Phone:  
KX-TGP500/KX-TGP550/KX-TGP551  
You must register this handset with your base unit before it can  
be used. This installation manual describes only the steps  
needed to register and begin using the handset. For further  
details, please read the base unit’s User Guide on the  
Panasonic Web site at:  
http://www.panasonic.com/sip (for users in the United States)  
Charge the batteries for about 6 hours before initial use.  
Please read this installation manual before using the unit and  
save it for future reference.  
Document Version: 2012-01  
 
 
LThe AC adaptor must remain connected at all times. (It is normal for  
the adaptor to feel warm during use.)  
LMake sure that the wall is strong enough to support the weight of the  
unit.  
Battery installation/Battery charge  
Important:  
LUse the supplied rechargeable batteries. For replacement, we  
recommend using the Panasonic rechargeable batteries noted on  
LWipe the battery ends (S, T) with a dry cloth.  
LAvoid touching the battery ends (S, T) or the unit contacts.  
LConfirm correct polarities (S, T).  
LUSE ONLY Ni-MH batteries AAA (R03) size.  
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.  
Charge for about 6 hours.  
LWhen the batteries are fully charged, the charge indicator goes off.  
Charge indicator  
Confirm  
Chargingis  
displayed.  
Rechargeable Ni-MH  
ONLY  
Note:  
LIf the batteries are fully charged, but the operating time seems to be  
shorter, clean the battery ends (S, T) and the charge contacts with a  
dry cloth and charge again.  
3
 
Registering a handset to the base unit  
1 Base unit:  
NKX-TGP500  
Press and hold {ALL} for about 4 seconds until the STATUS  
indicator flashes in red.  
NKX-TGP550/KX-TGP551  
Press and hold {ALL} for about 4 seconds until the registration tone  
sounds and the STATUS indicator flashes in red.  
LIf all registered handsets start ringing, press the same button to  
stop. Then repeat this step.  
LThe next step must be completed within 90 seconds.  
2 Handset:  
Press {OKL}, then wait until a long beep sounds.  
Note:  
LIf an error tone sounds, or if _ is still displayed, register the handset  
according to the registering section of the base unit’s User Guide on  
the Panasonic Web site. See page 1 for Panasonic URL.  
Display language  
1 {MENU} (center of joystick) i {#}{1}{1}{0}  
2 {V}/{^}: Select the desired setting.  
3 Press down the center of the joystick to save. i {OFF}  
4
 
Belt clip  
NTo attach  
NTo remove  
Wall mounting  
1 Drive the screws (not supplied) into the wall.  
2 Mount the charger (A), then slide it down (B) and to the right (C)  
until it is secure.  
25.4 mm  
(1 inch)  
A
B
C
Screws  
5
 
For your safety  
To prevent severe injury and loss of life/property, read this section carefully before  
using the product to ensure proper and safe operation of your product.  
WARNING  
Power connection  
L Completely insert the AC adaptor/power plug into the power outlet. Failure to do  
so may cause electric shock and/or excessive heat resulting in a fire.  
L Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it  
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause  
an insulation defect from moisture, etc. resulting in a fire.  
L Unplug the product from power outlets if it emits smoke, an abnormal smell, or  
makes an unusual noise. These conditions can cause fire or electric shock.  
Confirm that smoke has stopped emitting and contact your phone system dealer.  
Installation  
L To prevent the risk of fire or electrical shock, do not expose the product to rain or  
any type of moisture.  
L Do not place or use this product near automatically controlled devices such as  
automatic doors and fire alarms. Radio waves emitted from this product may  
cause such devices to malfunction resulting in an accident.  
CAUTION  
Installation and relocation  
L The AC adaptor is used as the main disconnect device. Ensure that the AC outlet  
is installed near the product and is easily accessible.  
Battery  
L We recommend using the supplied batteries or additional/replacement batteries  
noted on page 2 for replacement battery information. USE ONLY rechargeable  
Ni-MH batteries AAA (R03) size.  
L Risk of explosion if battery is replaced by an incorrect type. Dispose of used  
batteries according to the instructions.  
L Do not mix old and new batteries.  
L Do not open or mutilate the batteries. Released electrolyte from the batteries is  
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is  
toxic and may be harmful if swallowed.  
L Exercise care when handling the batteries. Do not allow conductive materials  
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit  
6
 
may cause the batteries and/or the conductive material to overheat and cause  
burns.  
L Charge the batteries provided with or identified for use with this product only, in  
accordance with the instructions and limitations specified in this manual.  
L Only use a compatible charger to charge the batteries. Do not tamper with the  
charger. Failure to follow these instructions may cause the batteries to swell or  
explode.  
Attention:  
A nickel metal hydride battery that is  
recyclable powers the product you have  
purchased.  
Please call 1-800-8-BATTERY (1-800-822-  
8837) for information on how to recycle this  
battery.  
Important safety instructions  
When using your product, basic safety precautions should always be followed to  
reduce the risk of fire, electric shock, and injury to persons, including the following:  
1. Do not use this product near water for example, near a bathtub, washbowl,  
kitchen sink, or laundry tub, in a wet basement or near a swimming pool.  
2. Do not use the telephone to report a gas leak in the vicinity of the leak.  
3. Use only the power cord and batteries indicated in this manual. Do not dispose  
of batteries in a fire. They may explode. Check with local codes for possible  
special disposal instructions.  
SAVE THESE INSTRUCTIONS  
Other information  
L Operating the product near electrical appliances may cause interference. Move  
away from the electrical appliances.  
Routine care  
L Wipe the outer surface of the product with a soft moist cloth.  
L Do not use benzine, thinner, or any abrasive powder.  
Notice for product disposal, transfer, or return  
L This product can store your private/confidential information. To protect your  
privacy/confidentiality, we recommend that you erase information such as  
7
 
phonebook or caller list entries from the memory before you dispose of, transfer,  
or return the product.  
FCC and other information  
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section  
68.316.  
When you hold the phone to your ear, noise might be heard in your Hearing Aid.  
Some Hearing Aids are not adequately shielded from external RF (radio frequency)  
energy. If noise occurs, use an optional headset accessory or the speakerphone  
option (if applicable) when using this phone. Consult with your audiologist or  
Hearing Aid manufacturer about the availability of Hearing Aids which provide  
adequate shielding to RF energy commonly emitted by digital devices.  
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST  
CALLS TO EMERGENCY NUMBERS:  
1) Remain on the line and briefly explain to the dispatcher the reason for the call.  
2) Perform such activities in the off-peak hours, such as early morning or late  
evenings.  
This device complies with Part 15 of the FCC Rules. Operation is subject to the  
following two conditions:  
(1) This device may not cause harmful interference, and (2) this device must accept  
any interference received, including interference that may cause undesired  
operation.  
Privacy of communications may not be ensured when using this phone.  
CAUTION:  
Any changes or modifications not expressly approved by the party responsible for  
compliance could void the user’s authority to operate this device.  
NOTE:  
This equipment has been tested and found to comply with the limits for a Class B  
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential  
installation. This equipment generates, uses, and can radiate radio frequency  
energy and, if not installed and used in accordance with the instructions, may  
cause harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the following measures:  
– Reorient or relocate the receiving antenna.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected.  
8
 
– Consult the dealer or an experienced radio/TV technician for help.  
FCC RF Exposure Warning:  
L This product complies with FCC radiation exposure limits set forth for an  
uncontrolled environment.  
L This handset may not be collocated or operated in conjunction with any other  
antenna or transmitter.  
L For body-worn operation, the handset must be used only with a non-metallic  
accessory. Use of other accessories may not ensure compliance with FCC RF  
exposure requirements.  
Notice:  
L FCC ID can be found inside the battery compartment or on the bottom of the unit.  
Compliance with TIA-1083 standard:  
Compatible with  
Telephone handsets identified with this logo have reduced  
noise and interference when used with T-Coil equipped hearing  
aids and cochlear implants.  
Hearing Aid T-Coil  
T
TIA-1083  
Notice  
LThis product is designed for use in the United States of America and Canada.  
Sale or use of this product in other countries may violate local laws.  
LCet appareil est conçu pour être utilisé aux États-Unis d’Amérique et le  
Canada. La vente ou l’emploi de cet appareil dans certains autres pays peut  
constituer une infraction à la législation locale.  
LEste producto está diseñado para usarse en los Estados Unidos de América.  
La venta o el empleo de este producto en ciertos países puede constituir  
violación de la legislación local.  
Lҏ౰ࠢட
छ୽
ٺ
ҢՄ೩Ȅषӵ
ڏ
т୽ড়᎛୵
ٺܖ
ҢȂџ૖ོႂІ࿋Ӵ
ٽݲ
Ȅ  
L
ߩߎ
⵾ຠ
ޔߪ
ᣣᧄ࿖ᄖ
ߩߢ
૶↪
⋡⊛
ߡߒߣ
⸳⸘
ޔࠅ߅ߡࠇߐ
ᣣᧄ࿖ౝ
ߩߢ
 
૶↪
ߪ
ᴺᓞ㆑෻
ࠅߥߣ
߹
ޕߔ
ޔߡߞ
ᒰ␠
ߪߢ
ᣣᧄ࿖ౝ
ߪߡ޿߅ߦ
ේೣ
ߒߣ
 
ߡ
ୃℂ
ࡆ࡯ࠨߩߤߥ
ߪ
ߨ߆ߒ
߹
ޕߔ
 
9
 
Industry Canada Notices and other information  
NOTICE:  
the cordless telephone further away  
This equipment meets the applicable  
from the TV or VCR. This will often  
Industry Canada Terminal Equipment  
reduce, or eliminate, interference.  
Technical Specifications. This is  
confirmed by the registration number.  
The abbreviation, “IC:”, before the  
registration number signifies that  
registration was performed based on  
a Declaration of Conformity indicating  
RF Exposure Warning:  
LThis product complies with IC  
radiation exposure limits set forth  
for an uncontrolled environment.  
LTo comply with IC RF exposure  
requirements, the base unit must  
that Industry Canada technical  
be installed and operated 20 cm  
specifications were met. It does not  
(8 inches) or more between  
imply that Industry Canada approved  
product and all person’s body  
the equipment.  
(excluding extremities of hands,  
wrist and feet).  
LThis product may not be collocated  
or operated in conjunction with any  
other antenna or transmitter.  
LFor body-worn operation, the  
handset must be used only with a  
Users should ensure, for their own  
protection, that the electrical ground  
connections of the power utility,  
telephone lines and internal metallic  
water pipe system, if present, are  
connected together. This precaution  
may be particularly important in rural  
non-metallic accessory. Use of  
areas.  
other accessories may not ensure  
compliance with IC RF exposure  
NOTICE:  
Operation is subject to the following  
requirements.  
two conditions: (1) this device may  
not cause interference, and (2) this  
device must accept any interference,  
including interference that may cause  
undesired operation of the device.  
Privacy of communications may not  
be ensured when using this  
telephone.  
Some cordless telephones operate at  
frequencies that may cause  
interference to nearby TVs and  
VCRs. To minimize or prevent such  
interference, the base of the cordless  
telephone should not be placed near,  
o
r on top of, a TV or VCR. If  
interference is experienced, move  
10  
 

Miele Ventilation Hood DA 337 I User Manual
Milwaukee Drill 54 16 5000 User Manual
MTD Yard Vacuum 24677L User Manual
NuTone Vacuum Cleaner CH515 User Manual
Nuvo Stereo System NV T3 User Manual
Omega Vehicle Security Thermometer HH804W User Manual
Omnimount TV Mount OM10059 User Manual
OWI Microphone CRS 101 User Manual
Panasonic Automobile Accessories EP 1080 User Manual
Panasonic Impact Driver EY7206 User Manual