S I M P L Y
A M A Z I N G ®
USER’S GUIDE
MODEL QS110 SERIES
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
Important Safety Instructions
Warranty
Operating Instructions
Warranty
ORECK MANUFACTURING COMPANY: (ORECK gives you the following limited warranty
for this product only if it was originally purchased for use, not resale, from ORECK or an
ORECK Authorized Retail Dealer.)
ORECK will repair or replace, free of charge, to the original purchaser, any part which is
found to be defective in material or workmanship within one (1) year of the date of purchase.
This limited warranty applies to normal domestic use. Any commercial use of this product will
void this limited warranty.
This limited warranty does not cover the replacement of expendable or consumable parts such
as belts, brushes, bulbs, dirt filters, batteries and other parts subject to normal wear.
This limited warranty does not apply to any part subjected to accident, abuse, commercial
use, alteration, misuse, damage caused by fire or act of God, the use of voltages other than
indicated on the serial number plate of this product or service of this product by other than
ORECK or an ORECK Factory Authorized Service Center.
ORECK does not authorize any person or representative to assume or grant any other warranty
obligation with the sale of this product.
ORECK’s limited warranty is valid only if you retain proof of purchase from ORECK or an
ORECK Authorized Retail Dealer for this product. If you purchase this product from any
other source, your purchase is “AS IS,” which means ORECK grants you no warranty, and
that you, not ORECK, assume the entire risk of the quality and performance of this product,
including the entire cost of any necessary servicing or repairs of any defects.
ORECK’s liability for damages to you for any costs whatsoever arising out of this statement
of limited warranty shall be limited to the amount paid for this product at the time of original
purchase, and ORECK shall not be liable for any direct, indirect, consequential or incidental
damages arising out of the use or inability to use this product.
Some states do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO
WARRANTIES, WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.
Some states do not allow limitations on the duration of implied warranties, so the above
limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary
from state to state.
2
Assembly
Model QS110 Series
1. Main housing
2. Hand held vacuum
3. Power head
4. Dirt Cup
5
5. ON/OFF handle switch
6. Handle control button
7. Release button for hand held vacuum
8. Charging socket
9. Hand held vacuum ON/OFF switch
10. Charging lamp
11. Release button for dirt cup
12. Dust filter (included in the hand held unit)
13. Adapter (power supply/charger)
6
7
8
2
12
1
9
10
4
11
3
13
3
Operating Instructions
Start-Up Instructions
1
The box should include
(a) Main housing (fig. 1)
(b) Power head (fig. 1)
(c) Adapter (power supply/charger)
(d) User’s Guide
a
Fig 1. Insert the power head into the
air intake of the main unit.
b
Charging the Unit
Fig 2. Before charging, make sure
both switches are in the “OFF”
position. Then insert the
2
adapter into an electrical outlet
and the plug into the charging
socket on the unit. Charge
batteries for 16 hours before
initial use.
ON / OFF
Switches
Caution: Do not allow the
battery to run down
completely before charging.
Running down battery will
cause battery life to shorten
severely.
Fig 3. A red lamp indicates the unit is
charging. It is normal for the
adapter to feel warm while the
battery is charging.
3
4
Recharge the unit as soon as
the motor power decreases
noticeably. The unit can be on
a constant charge so it is
always ready for use.
However, if the unit will not be
used for several weeks at a
time, unplugging it is recom-
mended.
Recharge
Lamp
Vacuuming
Fig 4. Push the slide switch forward
on the stick handle to clean
hard floor or carpet.
FLOOR - uses suction only for
vacuuming hard floors.
CARPET - uses suction and
engages brush roll to vacuum
4
Operating Instructions
Combining/Detaching
Hand Vac
5
Fig. 5 To remove the hand held unit,
push the release button and
pull the hand held unit outward.
Fig. 6 To replace the hand held unit,
insert the air intake of the hand
held unit into the main housing
(at the base of the unit). Push
the hand held unit back against
the back of the main unit
6
housing until the unit “clicks”
into place.
Emptying the Dirt Cup
Fig. 7 Press the release button and
remove the dirt cup from
cleaner.
7
8
Fig. 8 Remove the dust filter from
the dirt cup.
5
Operating Instructions
Cleaning the Dust Filter
9
Fig. 9 Empty dirt cup.
Fig. 10 Remove the filter frame from
10
the dust filter.
Fig. 11 Wash the filter in warm soapy
water, using a soft brush if
necessary. Dry the filter
completely before replacing it
into the filter frame and dirt
cup.
11
12
13
Replace the dust filter on the
filter frame and insert into dirt
cup.
Replace dirt cup onto handheld
vacuum.
Power Brush
Important: Disconnect cleaner from
electrical outlet.
Fig. 12 To maintain cleaning
effectiveness, regularly remove
hair, lint, strings, threads, etc.
from the brush roll with a knife or
scissors.
Storing the Vacuum
Fig. 13 Press the handle control button
and bend the handle down for
easy storage.
6
Troubleshooting Guide
PROBLEM
AREAS TO CHECK
What happens if the red charging indicator
is not lit while charging?
1. Make sure the adapter plug and
socket are plugged in properly.
2. Both the hand held unit and the stick
broom need to be turned off while
charging.
Suction power is not sufficient.
1. Empty dirt cup and clean dust filter.
2. Charge battery again.
3. Contact an Authorized Service Center.
Running time is not sufficient.
1. Charge battery again.
2. Contact an Authorized Service Center.
Machine does not stop when switched off.
1. Separate hand held unit from the
stick broom.
2. The switch on the hand held unit and
the switch on the the stick broom must
both be in the off position.
Brush does not work while operating.
1. Clean the power brush.
2. Make sure switch on handle is in the
“Carpet” position.
3. Contact an Authorized Service Center.
Hand held unit works, but the stick broom
does not.
1. Take the hand held unit off and locate
the three (3) silver prongs on the
bottom of the unit. Make sure the
contacts are clean and free of debris.
2. Contact an Authorized Service Center.
Accessories
QuickStick Accessory Kit
Includes:
QSKIT
Upholstery Brush
Accessory Stand
Flex Hose
Extension Tubes
Small Nozzle
Crevice Tool
Replacement Dust Filter
QSFILTER
7
Discarding the Vacuum
Remove the batteries by cutting the connector wires one by one before you discard
the appliance. Do not dispose of batteries with your regular household trash.
Dispose of them in an environmentally safe manner.
Battery Disposal
To preserve natural resources, please
recycle or dispose of expired battery
pack properly.
THIS PRODUCT CONTAINS A NICKEL-CADMIUM BATTERY.
IT MUST BE DISPOSED OF PROPERLY. LOCAL, STATE, OR
FEDERAL LAWS MAY PROHIBIT DISPOSAL OF NICKEL-
CADMIUM BATTERIES IN ORDINARY TRASH. CONSULT
YOUR LOCAL WASTE AUTHORITY FOR INFORMATION
REGARDING AVAILABLE RECYCLING AND/OR DISPOSAL
OPTIONS. FOR DISPOSAL INFORMATION, CALL THE
RECHARGEABLE BATTERY RECYCLING CORPORATION AT
1-800-8-BATTERY.
WARNING:
!
Upon removal, cover the battery pack’s terminals with heavy
duty adhesive tape. Do not attempt to destroy or disassemble
battery pack or remove any of its components. Nickel-
cadmium batteries must be recycled or disposed of properly.
Also, never touch both terminals with metal objects and/or
body parts as short circuit may result. Keep away from
children. Failure to comply with these warnings could result in
fire and/or serious injury.
8
9
10
©2004 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and
registered trademarks are owned and used under the authority of Oreck Holdings, LLC.
40322-01 REV A
01/05 ECN # R-7844
|