NuTone Fan ILRF User Manual

INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
In-Line Radon Fans  
Model: ILRF  
IMPORTANT SAFETY INSTRUCTIONS  
WARNING: TO REDUCE THE RISK OF FIRE. ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE  
THE FOLLOWING:  
A. Use this unit only in the manner intended by the manufacturer.  
If you have questions, contact the manufacturer.  
B. Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power  
from being switched on accidentally.  
When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to  
the service panel.  
• Suitable for use with solid state speed controls.  
CAUTION: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.  
INSTALLATION INSTRUCTIONS  
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE  
THE FOLLOWING:  
A. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes  
and standards, including fire-rated construction.  
B. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning  
equipment to prevent back drafting. Follow the heating equipment manufacturer's guideline and safety standards  
such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating,  
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.  
C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.  
D. Ducted fans must always be vented to the outdoors.  
E. NEVER place a switch where it can be reached from a tub or shower.  
WIRING  
1. Run 120v AC house power wiring through switch box to junction box in ventilator housing.  
2. Remove ventilator junction box cover.  
3. Refer to Figure 1. Connect the house power wire (black) to the terminal marked LI. Connect the house neutral  
wire (white) to the terminal marked N. The fan housing is fully insulated and therefore no grounding is required.  
4. Replace outlet box cover.  
5. Connect house power wire to the wall switch.  
NOTE: ALL WIRING MUST COMPLY WITH LOCAL ELECTRICAL CODES.  
 

Miele Food Warmer ESW 47XX User Manual
NuTone Ventilation Hood NS6500 Series User Manual
One for All Universal Remote URC 8800 User Manual
Optoma Technology Projector EP 758 User Manual
Oricom Two Way Radio UHF050 User Manual
P3 International Telephone P5090 User Manual
Panasonic Answering Machine KX T1720 User Manual
Panasonic Answering Machine KX TG2631AL User Manual
Panasonic Fax Machine KX FP205AL User Manual
Panasonic Personal Computer CF 37 User Manual