ICE S HOT D IS P EN SE R ꢀ
Model # CSD-250
Nostalgia Products Group LLC
1471 Partnership Dr.
Green Bay, WI 54304-5685
For Household Use Only
Read These Instructions Before Using This Unit!
Save These Instructions!
Visit Us Online at
©2009 Nostalgia Products Group LLC
Rev. 8/12/09
2
3
CLEANING
ABOUT YOUR ICE SHOT DISPENSER™ (Continued)
The ICE SHOT DISPENSER™ is easy to clean. Simply run hot water through the bottle stopper
by filling an empty bottle with hot water and allowing it to flow out through the spout. You can
also fill the ice bucket with hot water and allow it to flow through the aluminum coils. Dispose of
the water through the dispenser rear nozzle and plug.
Open your liquor bottle. Insert the
Bottle Stopper
Bottle Stopper into the bottleneck tightly.
To maintain the exterior finish of the ICE SHOT DISPENSER™, wipe down using a non abrasive
sponge or cloth with warm sudsy water and dry with a non abrasive clean cloth.
Flow Position
3.
4.
Turn the bottle upside down and insert the bottle
with the bottle stopper into the flow position
(above the dispenser) tightly.
Place a shot glass under the spout. Push the handle
forward. After about 60 seconds, your cold alcohol
shot will pour out while retaining all the
intensity of the flavor.
Spout
Handle
5.
As the ice melts, water will collect in a reservoir
inside the dispenser unit. Place a cup under the
drain nozzle located at the back side of the dispenser,
and remove the nozzle plug. Allow to drain completely.
Replace the nozzle plug when reservoir is emptied.
Nozzle & plug
|