NewAir Air Conditioner ACP 1300E User Manual

Contents  
1.Safety Instructions  
(1) Warning................................................................................... 2  
(2) Precautions.............................................................................. 3  
(3) Maintenance......................................... ................................... 4  
ACP-1300E Portable Air Conditioner  
Owner's Manual  
2. Parts List  
(1) ACP-1300E Unit and Accessories............................................... 5  
(2) Control Panel ........................................................................... 6  
(3) Remote Control......................................................................... 7  
3.Operating Instructions  
(1) Operating the ACP-1300E for the First Time; Operating Modes;  
and Thermostat.........................................................................8  
(2) Setting the Timer....................................................................... 9  
(3) Adjusting the Airflow...................................................................9  
(4) Installing the Battery for the Remote Control...............................10  
(5) Emptying the Auxiliary Water Tank.........................................11-12  
(6) Setting up the Exhaust Hose.................................................13-14  
4. Troubleshooting Tips.......................................................................15  
5. Electrical Diagram ..........................................................................16  
6. Electrical Specifications ................................................................ 17  
Please read all instructions carefully before operating  
1
1. Safety Instructions  
1. Safety Instructions  
Warning  
Precautions  
Connect the ACP-1300E's plug into an  
appropriate power outlet.  
Do not turn off the power supply by pulling  
the power cord; use the On/Off power  
button.  
Leave the ACP-1300E in an upright position for at least two hours before operating.  
The unit must be installed in accordance with national and local wiring regulations.  
The ACP-1300E's supply cord requires a Y-type attachment. If the supply cord is  
damaged, it must be replaced by the manufacturer, an authorized service agent, or a  
qualified repair professional in order to avoid further damage, to prevent voiding the  
warranty, and to avoid bodily injury.  
the power  
the ACP-1300E  
to be damaged.  
or an extension  
use a power strip  
not to damage  
do not operate  
appears  
Be careful  
cord, and  
if the cord  
Do not  
cord.  
Never operate the ACP-1300E in an area where flammable gasses or chemicals are  
present.  
To prevent electromagnetic interference, place the unit at least three feet away from  
radios or televisions.  
When connecting or disconnecting the power cord, hold the plug itself - never pull the  
power cord.  
When not using the unit for an extended period of time, disconnect the power cord and  
drain any water from the auxiliary water tank.  
To avoid injury, keep fingers and foreign  
objects out of the unit.  
the ACP-1300E,  
are  
clean and  
your hands  
operating  
Before  
make sure  
dry.  
When cleaning the ACP-1300E, do not spray liquid directly onto the unit. Moreover,  
do not use harsh chemicals or cleansers to clean the unit. Instead, apply water or a  
mild cleanser to a soft cloth and wipe the ACP-1300E clean.  
The ACP-1300E is not intended to support heavy objects, be used as a step-stool, or  
be shaken or bumped into. Keep this in mind when deciding where to place the unit.  
If you choose to use the continuous drain function on the ACP-1300E, make sure the  
condensate can drain off into an appropriate receptacle.  
Make sure the air conditioner's ground  
wire is connected.  
If you notice smoke or an odd odor coming  
from the ACP-1300E, turn the unit off and  
disconnect the power plug.  
To ensure adequate air circulation, place the air conditioner at least four inches away  
from walls and furnishings. Be aware of draperies or other items which may interfere  
with the intake vents and cause restricted airflow.  
Place the ACP-1300E on a level, flat surface. Do not operate the unit on an angle of  
more than 4 inches.  
your NewAir  
contact  
please  
unit malfunctions,  
center.  
repair  
or if the  
persist  
or a professional  
If problems  
dealer  
2
3
 
3.Operating Instructions  
3. Operating Instructions  
Setting the Timer Function:  
1.When first plugging in the ACP-1300E,  
a tone indicating that the power is connected  
will sound. After pressing the "On" button,  
the unit will start in Auto Mode and display  
the current room temperature.  
ON/OFF  
TEMP  
WIND  
To set the timer function, press the "Timer" button and enter the time that  
you would like the unit to shut down. You will then have the option of setting  
the time for the unit to resume function (ranging from half an hour to 12 hours,  
in half hour increments). You can also exit the timer function at that time.  
2.To select the mode, press the "Mode" button. This will then cycle the  
ACP-1300E through the "Auto," "Fan,""Cooling," and "Dehumidify" options.  
While the unit is in standby mode, you can also set the operation times by  
pressing the "Timer" button. Enter the time in which you would like the air  
conditioner to begin operating, and you will then be able to program the time  
at which you want the unit to go back into standby mode (ranging from half an  
hour to 12 hours, in half hour increments). You can also exit the timer  
function at that time (Note: While in the set time frame, the air conditioner will  
display a countdown of the remaining time until the next mode is initiated).  
Cooling  
Dehumidify  
Auto  
Fan  
3.When adjusting the temperature, keep in mind that the ACP-1300E is  
adjustable between 60O and 88O F. To set the temperature, press the "Temperature"  
button until the desired temperature is displayed. The air conditioner will now  
cool the room to that temperature. After five seconds of setting your desired  
temperature, the display will then revert back to displaying the current room  
temperature.  
To adjust the airflow, if you would like to have the airflow oscillated from the  
ceiling to the floor, press the "Oscillation" button on the remote control. Right  
to left airflow can then be set by manually adjusting the louvers.  
4.To adjust the fan speed, press the "Speed button." This will allow the  
ACP-1300E to cycle through the "High,""Medium," and "Low" speed  
options.  
Please Note:  
When turning off the unit, VFD indicators will appear "Off" until the sweep  
shuts down.  
High  
Low  
Mid  
5.To turn off the unit, press the "Off" button. The air conditioner will  
cease operation and a tone will sound.  
6.1.For fresh air, press the "Fresh Air" button while the unit is running.  
This will then engage the built-in ion generator.  
Please Note:  
While in dehumidification mode, the unit will automatically set the fan speed to  
"Low". The ACP-1300E will not allow fan speed adjustments, nor will adjusting  
the temperature affect the unit's operation.  
In addition, while in fan mode, adjusting the temperature will not affect the unit's  
operation. If the ACP-1300E is in standby mode, the remote control's memory  
function will turn on. Your settings will be stored in the unit's memory, and when  
used next, it will operate according to the last saved settings only the timer  
function will need to be reset (if you are using this function).  
8
9
3. Operating Instructions  
3. Operating Instructions  
Drainage  
Battery Installation:  
When the ACP-1300E is in operation, the condensed water will be drained into  
the water tank. If the water tank is full, a buzzer will sound 20 times, and the VFD  
indicator will display an "E2" error warning. At that time, the unit will cease  
operation, and if you wish to restart the unit, the water tank must be emptied by  
taking the following steps:  
1.Open the battery compartment by sliding down the battery cover  
panel.  
2.Remove and discard old batteries replace with new batteries  
3.Replace the battery panel back onto the remote.  
1.Turn off the unit.  
2.Remove the rubber plug. The condensed water will then flow out.  
3.After the water is emptied, replace the rubber plug.  
4.Restart the unit.  
Battery  
Remote Control Panel  
Battery Cover Panel  
Please Note:  
1.The polarity of the batteries must match the indicator in the remote control.  
2.Do not mix old and new batteries in the remote control.  
3.To prevent corrosion, remove the batteries if the remote control will not be used  
for an extended period of time.  
Drainage Hole  
Rubber Plug  
Water Tank  
10  
11  
 
3. Operating Instructions  
3. Operating Instructions  
Air Exhaust Hose  
Exhaust Hose  
The hot air exhaust conducts the hot, moist air produced by the unit away from  
the space you are cooling. The window kit and exhaust hose can also be moved  
from room to room with the unit. You can exhaust the ACP-1300E by following  
one of the following two methods:  
1.The exhaust hose can extend  
from 1.8 feet to 6.5 feet. The  
shorter the hose , the better  
the cooling effect .  
1.Exhaust the hot air through a window or sliding glass door (a window  
kit extension may be necessary). Open the window or sliding glass  
door, install the window kit, and connect the exhaust hose.  
2.The hose should be as straight  
as possible, as sharp or unnece  
-ssary bends in the hose will prevent effective airflow.  
This will subsequently result in overheating and possible  
shut-down of the unit.  
2.If an existing window or sliding glass door cannot be used, a custom  
opening through a wall or ceiling can be cut out in order to facilitate  
the exhaust hose.  
3.The length of the exhaust hose  
should not be extended past 6.5  
feet. Replacement hoses are  
available for purchase through  
your NewAir vendor. We also  
recommend that you use only  
certified NewAir replacement  
parts.  
Please Note:  
The hot air must be exhausted in order for the unit to produce a cooling effect.  
When the ACP-1300E is not in use, safely store away the exhaust hose in a  
clean, dry place.  
12  
13  
5. Electric Diagram  
4. Troubleshooting  
Troubleshooting Your ACP-1300E Portable Air Conditioner  
Before investing in repairs, check to see if any of the following apply to you:  
Suggested Solutions  
Problems  
Possible Causes  
There could be power trouble.  
1.The power cord is not  
plugged in.  
2.The circuit breaker has  
been tripped.  
3.There is a problem with  
the socket or outlet.  
4.Either the power cord is  
damaged, or the fuse  
needs to be replaced.  
1.Connect the power cord corre-  
ctly.  
2.Reset the circuit at the breaker  
box.  
The unit doesn't work.  
3.Change the socket or outlet.  
4.Take the unit to a qualified techn-  
ician and have the fuse replaced  
(fuse specification: 3A/250V).  
Either the timer has been  
activated or the temperature Either turn the timer off or wait  
The unit stops working on its own.  
in the room is lower than the  
set temperature.  
for the room temperature to rise.  
1.Wait for the room temperature  
to rise to resume normal  
operation.  
2.Allow the evaporator to defrost  
and normal operation will  
resume.  
1.The room temperature is  
lower than the set temp-  
erature.  
2.The evaporator is frosted  
over.  
There is no cool air coming out  
of the unit when it is in cooling  
mode.  
1.The evaporator is frosted  
over.  
2.The unit is eliminating frost.  
Allow the evaporator to defrost  
andnormal operation will resume.  
There is no cool air coming out of  
the unit when it is in dehumidifying  
mode.  
Error code E2 is displayed on the  
control panel.  
Empty the water tank and restart  
the unit.  
The water tank is full.  
Error code E4 is displayed on the  
control panel.  
Replace the coil pipe.  
The coil pipe is damaged.  
1.Restart the unit when the voltage  
is normal.  
2.Have the unit repaired by your  
NewAir dealer or at a professional  
repair center.  
1.The voltage is too high or  
too low.  
2.The unit is damaged.  
Error code E1 is displayed on the  
control panel.  
Please Note:  
Never service your ACP-1300E portable air conditioner by yourself.  
If your unit needs to be repaired, please contact your NewAir dealer  
or a professional repair center for assistance.  
14  
15  
 
6. Technical Specifications  
ACP-1300E  
13000(MAX)  
120(MAX)  
Model Number  
Cooling Capacity (Btu/h)  
Dehumidifying(Pints/day)  
Power Supply  
120V/60Hz  
Cooling  
Power  
1250W/10.8 A  
950W/ 8.2A  
2L  
Consumption  
Dehumidifying  
Water Tank Capacity (Liters)  
Temperature Set Range  
Noise Level(dB)  
61 F-88 F  
52  
Unit Weight (Lb)  
Unit Dimensions (inches)  
Refrigerant  
88  
13.8X17.4X34.2  
R22(21.2oz)  
Please Note:  
The cooling capacity of the unit may be affected by several factors such as  
the height of the ceiling, the quality of insulation, number of windows, etc.  
16  
 

MTD Spreader 439 305 User Manual
MTX Audio Stereo Amplifier RT10 04 User Manual
NAD DVD Player L 54 User Manual
Navigon GPS Receiver 12xx User Manual
NordicTrack Home Gym 236670 User Manual
Oki Printer 58377901 User Manual
Omega Speaker Systems Stereo Amplifier PH 2720 PA User Manual
Orion Car Audio Car Speaker XTR402 User Manual
Panasonic Car Video System CQ VX220W User Manual
Patton electronic Marine Battery 2017P60 RS 232 to 60mA User Manual