MBR624U_IG.fm Page 1 Thursday, November 13, 2008 6:23 PM
Connecting Your Router and Applying Power
Configuring Your Router’s Internet Connection
)NSTALLATION 'UIDE
1. Connect one end of the Ethernet cable that came with your router into a LAN port on
the router, and the other end into the Ethernet port of your computer.
1. From the Ethernet connected computer, open a Web browser.
3G Mobile Broadband Wireless Router MBR624GU
address field of your browser.
Start Here
Your wireless 3G USB modem (sold separately) must be activated before you install the
router. For a list of compatible wireless USB modems, see the NETGEAR website at
computer with an Ethernet port. Your computer must be configured with DHCP (most PCs
are).
The Setup Wizard Welcome screen displays.
Connecting the Wireless 3G USB Modem
1. At the location where you will install the router, connect your activated 3G USB
modem to your computer. Follow the instructions from your Internet Service Provider
(ISP) to connect to the Internet from your computer.
2. Plug in the power adapter to your router, and push the Power button on the rear panel.
2. Verify that you can connect to the Internet. Then, close the software that you used to
connect to the Internet.
Note: If you connect to the router after initial configuration, a log in prompt displays. See
3. Place the router in its vertical stand,
and adjust the antenna.
3. Click Next, and the Setup Wizard configures your router’s Internet connection.
For best performance, place the router
in a location where your 3G USB
modem Internet connection is strong,
such as on a desk near a window
instead of on the floor.
When the Internet connection is working, a Connection Success message displays.
this document.
other side of this document.
4. Connect your wireless 3G USB
modem with activated Internet
service to the USB port on the rear
panel of the router using a USB cable
or docking station.
3. Verify that the following LEDs on the front of the router light up:
•
•
•
Power. Power is supplied to the router.
LAN. Your computer is securely connected to this LAN port on the router.
USB. Your wireless USB modem is securely connected to the router.
5. If your wireless 3G USB modem has
a separate antenna, adjust it as
needed.
•
•
Wireless. There is a wireless signal from the router.
Internet. This LED is red because the router is not connected to the
Internet.
|