INSTALLATION INSTRUCTIONS FOR PART 99-7324
APPLICATIONS
KIA Optima
2006.5-2010
99-7324
KIT FEATURES
• DIN head unit provision with pocket
• ISO DIN head unit provision with pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) Trim Plate
C
B
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-1004 - Hyundai 2006-up/KIA harness 2004-up
• 70-7303 - Hyundai / KIA Harness 2009
Antenna Adapter:
A
• 40-KI11 - 2009-10 Kia Optima
TOOLS REQUIRED:
Phillips Screwdriver • Small Flat Blade Screwdriver/
Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
99-7324 DASH DISASSEMBLY
KIA OPTIMA 2006.5-2010
A
1
2
3
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
Unclip and remove the panel sur-
rounding the radio including the a/c
vents and climate controls. (Figure A)
Remove (4) Phillips screws securing
radio. Unplug and remove radio.
(Figure B)
B
Continue to kit assembly.
3:05
EQ
FM
AM
CD
103.5 FM
SCAN
AUDIO
POWER
1
2
5
3
RDM
FF
REW
SEEK
TRACK
4
6
RPT
TUNE
VOLUME
1
99-7324 KIT ASSEMBLY
DIN HEAD UNIT PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
1
2
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs outward
(Figure A)
Slide the aftermarket radio into the
cage until it snaps into place.
(Figure B)
Continue to final assembly.
B
2
99-7324 KIT ASSEMBLY
ISO DIN HEAD UNIT PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
1
Mount the ISO Brackets to the
radio using the screws supplied
with the radio. (Figure A)
2
3
Slide the radio into the radio open-
ing until the side clips snap into
place. (Figure B)
Snap the trim plate onto the front
of the Radio Housing. (Figure B)
B
Continue to final assembly.
3
99-7324 FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4
99-7324
NOTES
5
99-7324 INSTRUCTIONS
1-800-221-0932
REV. 04/27/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7324
|