KIT COMPONENTS
ALL VEHICLES
Radio Housing
5
Fig. B
Fig. A
99-7413
INSTALLATION
INSTRUCTIONS
Faceplate
Fig. C
2-SHAFT HEAD UNITS: Snap the Faceplate
into the Radio Housing, slide the aftermarket
head unit into the kit and secure with shaft
nuts. (seeFig. A)
APPLICATIONS
ISO-DIN
Spacers
CAR
NISSAN
PAGE
DIN HEAD UNITS: Slide the DIN cage into the Housing and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)
Mounting
Brackets
Altima 1993-97........................................................... 1
Altima 1998-01........................................................... 2
ISO-DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate. Snap the
Faceplate into the Housing and attach theISO-DIN Spacers to the inner walls of the Mounting
Brackets by inserting the Spacer pegs into the Bracket holes. Slide the aftermarket head unit
into the back of the kit and mount the Brackets to the unit with (4) 5mm Flat-head Screws
supplied. (seeFig. C)
(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure.
IfanequalizerwillNOTbeincluded, snaptheEqualizerDummyPlate intotheopening).
Equalizer
Dummy Plate
6
7
A
B
(4) 5mm Flat-head
Screws
C
(6) #6 Self-tapping
Screws
D
TOOLS REQUIRED
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Phillips screwdriver
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) Phillips screws
removed in step #1.
Cutting tool
Wrench
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 250701
3
|