KIT FEATURES
5
ISO-DIN
head unit
provisions
99-5716
INSTALLATION
INSTRUCTIONS
Incorporates
factory climate
controls into
installation
Fig. A
(located under
the rear deck)
Fig. B
KIT COMPONENTS
APPLICATIONS
Open the trunk, remove (4) pop-clips from the driver's side trunk liner and remove the liner.
(see Fig. A). Locate the factory tuner on the wall of the trunk and disconnect the speaker and
antenna plugs (it is NOT necessary to remove the tuner). (see Fig. B). Plug the 70-5715 into
the unit speaker plug and the antenna extension lead into the unit antenna plug. Slide the
extension harness through the space in the back seat between the seat back and seat bottom.
Unclip the rocker trim, tuck the extension harness under the carpet and stretch the harness to
the back of the dash. (Replace the rocker trim when completed). Splice the speaker leads on
the extension harness into the rear of the aftermarket head unit. Plug the factory wiring
harnesses into the switch connectors (previously mounted in step #2) and audio connectors
on the back of theIntegratedMountingKit.
CAR
PAGE
FORD
Taurus 2000-2003..................................................1-3
MERCURY
Sable 2000-2003.....................................................1-3
Integrated
Mounting Kit
ISO Faceplate
6
Extension
s
(2) #8 x 3/8"
Phillips Pan-head Screws
TOOLS REQUIRED
86-5618 - Head unit
removal keys
Re-connect the battery terminal and test the unit, climate controls and rear defroster for proper
operation. Snap the IntegratedMountingKit assembly into the sub-dash.
1-800-221-0932
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Torx-head screwdriver
rev. 03/08/07
INST99-5716
3
|