7623123
WATER CURTAIN SWITCH UPDATE KIT
USED ON G-1200 AND G-1700 SERIES ICE MACHINES
Kit Includes: 2 springs, P/N 3300113
2 brackets, P/N 6268714
The water curtain spring, installed, will increase the return
strength of the water curtain switch arm.
The new switch activating bracket is made out of a lighter gauge
stainless steel for easier mobility.
INSTALLATION INSTRUCTIONS:
1. Disconnect power supply.
2. Remove the left-hand side panel.
3. Remove the actuator retainers and switch activating brackets by removing the screws
supporting them (one in each, front and rear).
4. Remove the two screws supporting the switch mounting bracket and pull out the bracket
and switch assembly. Using needle-nose pliers, install the supplied springs into each
water curtain switch (one in each, front and rear), as shown in Fig. 2.
5. Reassemble the bracket and switches in their original positions.
6. Replace the switch activating brackets with the new ones supplied (front and rear).
Reassemble the actuator retainers, with the new switch activating bracket, in their
original positions. Note: All parts must be burr free.
7. Readjust the water curtain switches for proper operation, as necessary. See these
instructions on the inside of the front panel.
Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879
8003553
Rev. 10/09/03
|