Magnadyne Security Camera C SDL User Manual

Owner’s/Installation Manual  
Color Side View  
Security Camera  
Models: C-SDL Left  
C-SDR Right  
For Technical Assistance, please call (800) 638-3600,  
 
Adjusting the Camera  
Marking on Camera  
Housing Indicates  
Up Position  
Do Not Adjust  
Adjustment Screws  
Do Not Adjust  
1. With the housing removed, loosen the  
adjustment screws located near the base of  
the camera.  
3. Tighten the adjustment screws to lock  
camera into place.  
Note: Do not over tighten the screws.  
2. Adjust the camera to the desired viewing  
angle.  
4. Reinstall the housing.  
Warning  
Backing Up Your Vehicle  
The product is intended to assist in safe driving and allows the driver to have a broader field of  
vision during backup. You, as the driver, are solely responsible for the safe operation of your vehi-  
cle and the safety of your passengers and pedestrians, and abiding all state and local traffic regu-  
lations. Do not use any features of this system to the extent it distracts you from safe driving. Your  
first priority while driving should always be the safe operation of your vehicle. Magnadyne will not  
accept any responsibility whatsoever for accidents and/or injuries resulting from failure to observe  
these precautions or safety instructions.  
Maintenance  
Although this Side View Security Camera requires little care, you can still maintain its condition and  
performance by following these steps:  
• Occasionally clean the camera lens with damp soft cloth.  
Should you experience any problem with the camera please refer to the troubleshooting guide  
below prior to returning your camera for repair.  
Note: The user should not attempt to service the unit beyond that described in the operating  
instructions. All other servicing should be referred to qualified personnel.  
Troubleshooting  
Symptoms  
Solutions  
Cloudy Image  
• Clean Dirty Camera Lens  
• Check Power Connections  
• Check Camera Mounting  
• Check Mounting Hardware  
• Check Power Connections  
No Power / Image  
Upside Down Image  
Unstable Image  
3
 
Specifications  
Image Sensor:  
Board Lens:  
1/3" Sharp Color CCD with Low Illumination  
2.8 mm  
Resolution:  
420 TV Lines  
48dB (AGC On)  
120°  
Internal Synchronization  
1 Lux  
1.0Vp-p 75 ohm  
Ip66  
120 mA  
350g  
-20°C ~ -70°C  
S/N Ratio:  
Diagonal Lens Angle:  
Sync System:  
Minimum Illumination:  
Video Output:  
Water Resistance:  
Power Consumption:  
Camera & Bracket Weight:  
Operating Temperature:  
Warranty  
ONE (1) YEAR LIMITED WARRANTY  
Magnadyne Corporation or its authorized agents will within one year from the date of sale  
to you, repair, replace or refund the retail sales price of said product or any part thereof, at  
the option of the Magnadyne Corporation or its authorized agents, if said product or part  
is found defective in materials or workmanship, when properly connected and operating on  
the correct power requirements designated for the specific product. This warranty and  
Magnadyne Corporation or its authorized agent’s obligations hereunder do not apply where  
the product was; damaged while in the possession of the consumer, subjected to unrea-  
sonable or unintended use, not reasonably maintained, utilized in commercial or industrial  
operations, or serviced by anyone other than Magnadyne Corporation or its authorized  
agents, or where the warning seal on the product is broken or the power and/or plugs are  
detached from the unit. Magnadyne Corporation or any of its authorized agents will not  
assume any labor costs for the removal and reinstallation of any product found to be defec-  
tive, or the cost of transportation to Magnadyne Corporation or its authorized agents. Such  
cost are the sole responsibility of the purchaser.  
This warranty does not cover the cabinet appearance items or accessories used in con-  
nection with this product, or any damage to recording or recording tape, or any damage to  
the products resulting from improper installation, alteration, accident, misuse, abuse or  
acts of nature.  
MAGNADYNE CORPORATION OR ITS AUTHORIZED AGENTS SHALL NOT BE LIABLE TO  
ANYONE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES OR CLAIMS EXCEPT THOSE  
ACCORDED BY LAW. NO EXPRESSED WARRANTY OR IMPLIED WARRANTY IS GIVEN  
EXCEPT THOSE SET FORTH HEREIN. NO IMPLIED WARRANTY SHALL EXTEND BEYOND  
ONE YEAR FROM THE DATE OF SALE.  
This warranty extends only to the original purchaser of the product and is not  
transferable. Some states do not allow limitations on how long an implied warranty lasts,  
and some states do not allow the exclusion or limitation of incidental or consequential  
damages, so the above limitations or exclusion may not apply to you. This warranty gives  
you specific legal rights, and you may have other rights that vary from state to state.  
“NOTE: The manufacturer is not responsible for any radio or TV interference caused by  
unauthorized modifications to this equipment. Such modifications could void the User’s  
authority to operate the equipment.”  
Defective merchandise should be returned to the original point of purchase or  
secondly, to Magnadyne Corporation, 1111 W. Victoria Street, Compton CA 90220.  
Return Authorization must be obtained before sending, or merchandise may be refused.  
C-SDL/R-UMIM Rev. A 3-20-08  
Copyright © 2008 Magnadyne Corp.  
 

Lexar Media Computer Accessories LRW025URBNA User Manual
Lincoln Electric Welder 10R User Manual
Link electronic Network Card DigiFlex 1190 User Manual
Logik Portable DVD Player LPD850 User Manual
LOREX Technology Switch CVA6933 User Manual
Makita Saw 4191DWA User Manual
Matrox Electronic Systems Computer Hardware Matrox RTX2 User Manual
McCulloch Lawn Mower 1 R User Manual
Metra Electronics Automobile Accessories 99 5819 User Manual
Metra Electronics Automobile Accessories 99 8157B User Manual