HEARTH PRODUCTS
KITS AND ACCESSORIES
506033-11
REV. NC 12/2008
STONE PANEL KITS
BELLA™
INSTALLATION INSTRUCTIONS FOR DECORATIVE TRIM
PANEL KITS FOR USE WITH THE BELLA™ PELLET STOVE
KIT CONTENTS (See Figure 1)
GENERAL INFORMATION
2 ea. Side Panels (9-1/8” x 17-1/4” item #1)
1 ea. Front Panel (15-5/8” x 4-7/8” item #2)
2 ea. Protective Tape
All of these parts may scratch or break, great care should be used in
handling them.
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact you local distributor
or dealer. Read this instruction sheet in its entirety before beginning the
installation. Failure to understand and follow these directions may result
in damage to the stone panels.
1 ea. Instruction Sheet
Cat. #
H3485
H3488
H3491
Model
Description
Stone Panel Kit, Tan Brown
BELLA-PK-TB
BELLA-PK-GV
BELLA-PK-SS
Stone Panel Kit, Gallo Veneziano
Stone Panel Kit, Beatrice Soapstone
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND OP-
ERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO THESE
INSTRUCTIONS.
TURN OFF THE STOVE AND ALLOW IT TO COMPLETELY COOL BEFORE
PROCEEDING.
TOOLS NEEDED
1/8” Allen Wrench
5/32” Allen Wrench
3/8” Open End Wrench
IMPORTANT NOTE: Failure to follow these steps may result in damage
to the enamel or painted surfaces as well as the stone.
INSTALLATION INSTRUCTIONS
Step 1. Apply protective tape to the front edge of the right side door, and
the back (right) edge of the front door (see A in Figure 3).
Step 2. Locate the two right side door retaining screws (see Figure 2).
Step 3. Using a 5/32” allen wrench and a 3/8” open end wrench remove
the two screws from the right side door. Note: the screws do not
have to be completely removed from the stove body, only the
right side door.
1
2
Figure 1 - Kit Contents
Figure 2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1
|