• ADM loop technology with
Apollo/Discovery protocol
• Ideal supplement to common smoke
detectors
• Sensitivity selectable in 5 steps
• Optional connection of remote
indicator
• Sealed electronics
Description
The Carbon Monoxide Detector AC-58000-300 uses a ween the fire detection control panel and the detector.
durable electrochemical CO sensor. It is an ideal sup- That ensures a periodical function testing of the detec-
plement to common smoke detectors because it is in- tor.
sensitive to the usual vapors and household products,
in low concentrations. The carbon monoxide detector The two LEDs with 360° visibility indicate the activated
does not respond to smoke particles and heat, and condition of the detector. The detector address is se-
therefore it shall only be used in addition to smoke or lected by means of a code card in the detector base.
heat detectors. Besides, the size of the fire area shall Therefore the detector can be changed without additi-
not exceed 50m2.
onal tools.
The proven ADM loop technology with Apollo/Discovery The detector can be attached to different types of ba-
protocol establishes a permanent communication bet- ses, and it can be protected against theft.
Specifications
Operating voltage
Current consumption
Ambient temperature
Relative humidity
Dimensions ø × H
Colour
Supply through loop voltage
typ. 400µA (quiescent)
0°C to +40°C (no condensation)
15 – 90% (no condensation)
100 × 42 (mm)
white
Weight
105g
Order number
Order name
243100
CO-Detector/Anal./Disc/Apo AC-58000-300
Building Safety. Building Security.
A
© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
AC-58000-300_DBL_LST_EN_0804.PDF • PAGE 1
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
|