Kramer Electronics Digital Photo Frame T6F 23 User Manual

The Kramer T6F-23 inner frame

Mounting the Inserts

Congratulations on purchasing your Kramer T6F-23 inner frame for the TBUS-6xl Table

Connection bus.

user manuals and the complete list of Kramer wall plates and

module connectors.

The T6F-23 inner frame includes:

You can rearrange or remove any of the plates mounted on the inner frame and replace them

•

2 openings for 2 power sockets

2 blank inserts

•

1 pass-through opening

with Kramer passive wall plates or connector modules for interfacing A/V type signals.

To mount a Kramer insert or connector module:

1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the

blank plate.

2. Place the required Kramer insert over the opening, insert the two screws to fix the Kramer

insert in place, and tighten them.

Installing the Assembled Inner Frame

To install the T6F-23 inner frame:

1. Place the assembled inner frame inside the TBUS-6xl enclosure.

Figure 1: T6F-23 inner frame (P/N: 80-004499)

2. Set the required height using your fingers to bring the inner frame to the desired position,

screw and tighten it in place using the height adjustment screws supplied with the inner

frame.

Power Socket and Power Cord Options

Various power sockets and power cords are available to use with the T6F-23, as described in the

“TBUS Modular Power Socket Installation and Power Cord” Installation Instructions, supplied with

the power socket.

Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so on):

1. Insert the cables to their appropriate connectors from underneath.

Each power socket comes with detailed assembly instructions.

2. Secure the cables to the tie holes on the TBUS-6xl.

Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

The T-2INSERT Kit Option (80-00006699)

After the TBUS-6xl is connected to mains power and the proper cables, it is ready for use.

You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)

instead of a power socket.