Klipsch Speaker System Quintet SL User Manual

Quintet SL  
Owner’s Manual  
 
QUINTET SL SPEAKER SYSTEM  
IMPORTANT SAFETY INSTRUCTIONS  
PLACEMENT  
1. READ these instructions.  
Before You Start – Some Klipsch speakers have feet and other  
accessories that may need to be installed prior to use. Please  
refer to Diagrams 1, 2, 3 and 4 for installation.  
2. KEEP these instructions.  
3. HEED all warnings.  
4. FOLLOW all instructions.  
5. DO NOT use this apparatus near water.  
6. CLEAN ONLY with dry cloth.  
Left and Right Main Channel Speakers – For optimum  
performance, place your speakers 6 to 15 feet (2 to 4.5m) apart  
and at least 24 inches (60.8cm) from side walls. They may also  
be toed-in slightly for better stereo imaging. The listening  
position should be approximately 1 to 1.5 times the distance  
separating the speakers. Refer to figures 1, 2 and 3 for  
connection and placement.  
7. DO NOT block any ventilation openings. Install in accordance  
with the manufacturer's instructions.  
8. DO NOT install near any heat sources such as radiators, heat  
registers, stoves, or other apparatus (including amplifiers) that  
produce heat.  
Center Channel Speakers – Center channel speakers are  
designed to place dialogue and primary sounds so that they  
appear to come from the video screen. The speakers should  
therefore be placed as close to the screen as possible, preferably  
directly on top of or below the screen. Refer to figures 2, 3 and 4  
for connection and placement.  
9.  
ONLY USE attachments/accessories specified by the  
manufacturer.  
10. USE only with a cart, stand, tripod, bracket, or table specified  
by the manufacturer, or sold with the apparatus. When a cart is  
used, use caution when moving the cart/apparatus  
combination to avoid injury from tip-over.  
Rear Surround Channel Speakers – Rear surround speakers  
are designed to recreate the sense of space and ambiance that  
many of today’s surround sound technologies provide. Quintet  
surround speakers can be placed on the wall directly adjacent to  
or on the wall behind the listening position using the foot as the  
mounting bracket. Refer to Diagram 4 and Figures 2 and 4 for  
connection and placement.  
11. REFER all servicing to qualified service personnel. Servicing is  
required when the apparatus has been damaged in any way,  
such as power-supply cord or plug is damaged, liquid has been  
spilled or objects have fallen into the apparatus, the apparatus  
has been exposed to rain or moisture, does not operate  
normally, or has been dropped.  
This symbol indicates that there are important  
operating and maintenance instructions in the  
literature accompanying this unit.  
CONNECTIONS  
Conventional Connection – Using 16-gauge or larger speaker  
wire, connect the RED “positive” (+) terminal of the LEFT speaker  
to the RED “positive” (+) terminal of your amplifier’s LEFT  
channel. Connect the BLACK “negative” (-) terminal of the LEFT  
speaker to the BLACK “negative” (-) terminal of your amplifier’s  
LEFT channel. Repeat this procedure for connecting all remaining  
speakers to the appropriate amplifier channels. Refer to Figure 4.  
Make sure no bare wires from any of the connections touch any  
other bare wires or terminals as this could cause a short and  
damage your equipment.  
This symbol indicates that dangerous voltage  
constituting a risk of electric shock is present within  
this unit.  
To reduce the risk of fire or electrical shock, do not expose this  
product to rain or moisture. The product must not be exposed to  
dripping and splashing and no object filled with liquids - such as a  
vase of flowers - should be placed on the product.  
No naked flame sources - such as candles - should be placed on  
the product.  
Amplifier Requirements – Klipsch speakers are highly  
efficient and will work well with a wide variety of ampli-  
fiers. Due to the high output levels Klipsch speakers are  
capable of reproducing, exercise caution with the volume control.  
Excessive volume over long periods of time can permanently  
damage your hearing. Overdriving your amplifier could also  
damage your speakers. Check with your dealer to make sure  
your particular amplifier is best suited to your application. We  
want you listening for a lifetime.  
WARNING: Voltages in this equipment are hazardous to life. No  
user-serviceable parts inside. Refer all servicing to qualified  
service personnel.  
CARE AND CLEANING  
CAUTION: Changes or modifications not expressly approved by the  
manufacturer could void the user’s authority to operate this device.  
Your speakers have a durable finish that should only require dry  
dusting. Avoid use of abrasive or solvent-based cleaners and  
harsh detergents. The brush attachment of your vacuum or a  
damp cloth should remove any dust from your speaker grilles.  
IMPORTANT: Promptly inspect your speakers for any shipping  
damage that may have occurred during transit. If you discover  
any concealed shipping damage, please report it to your dealer  
or the shipping company responsible for your product’s safe  
transit. Keep all original cartons and packing material for future  
safe transport.  
 
Warranty – U.S. and Canada  
Klipsch warrants to the original retail purchaser that this product is to be PAID FOR THE PRODUCT THAT IS THE SUBJECT OF THE CLAIM. SOME  
free from defective materials and workmanship for a period of five (5)  
years, from the date of purchase, if it is properly used and maintained. If  
this product proves defective in either material or workmanship, Klipsch,  
at its option, will (a) repair the product, or (b) replace the product, at no  
charge for parts or labor. If the product model is no longer available and  
cannot be repaired effectively or replaced with an identical model,  
Klipsch at its sole option may replace the unit with a current model of  
equal or greater value. In some cases, modification to the mounting sur-  
face may be required where a new model is substituted. Klipsch  
assumes no responsibility or liability for such modification. To obtain a  
repair or replacement under the terms of this warranty, please contact  
our customer service group at 1-800-KLIPSCH. You will be required to  
submit a copy of the original receipt via fax or email. The receipt must  
reflect that you are the original purchaser, the product was bought from  
an authorized Klipsch retailer, and the product is still within warranty. You  
will be issued a return authorization number (RA#) and asked to ship the  
defective product, together with proof of purchase and RA#, prepaid  
insured to the address set forth Klipsch 137 Heampstead #278 Hope,  
AR 71801. Freight collect shipments will be refused. Risk of loss or  
damage in transit is to be borne by the purchaser. Once Klipsch receives  
the defective product, a repair or replacement order will be initiated.  
Limitations:  
STATES, JURISDICTIONS OR COUNTRIES DO NOT ALLOW THE EXCLU-  
SION OR LIMITATION OF SPECIAL, INDIRECT, INCIDENTAL OR CONSE-  
QUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY  
NOT APPLY TO YOU.  
Warranty Outside the U.S. and Canada  
The Warranty on this product if it is sold to a consumer outside of the  
United Sta  
tes and Canada shall comply with applicable law. To obtain  
any applicable warranty service, please contact the dealer from which  
you purchased this product, or the distributor that supplied this product.  
FCC Information  
This device complies with Part 15 of the FCC Rules. Operation is subject  
to the following two: (1) This device may not cause harmful interference,  
and (2) this device must accept any interference received, including  
interference that may cause undesired operation.  
This equipment has been tested and found to comply with the limits for  
a Class B digital device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses  
and radiates radio frequency energy and, if not installed and used in  
accordance with the instruction, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will  
not occur in a particular installation.  
This limited warranty does not cover failure of the product  
resulting from improper installation, misuse, abuse, acci  
dent, neglect, mishandling, or wear from ordinary use or  
environmental deterioration.  
In accordance with FCC requirements, changes or modifications not  
expressly approved by Klipsch could void the user’s authority to operate  
this product.  
This limited warranty does not cover cosmetic damage,  
including paint damage, or consequential damage to other  
components or premises which may result for any reason  
from the failure of the product.  
This device generates and uses radio frequency (RF) energy, and if not  
installed and used properly, this equipment may cause interference to  
radio and television reception.  
This limited warranty is null and void for products not used  
in accordance with Klipsch’s instructions.  
This limited warranty is null and void for products with  
altered or missing serial numbers and for products not  
purchased from an authorized dealer.  
If this equipment does cause interference to radio or television reception  
(which you can determine by unplugging the unit), try to correct the  
interference by one or more of the following measures:  
Re-orient the receiving antenna (that is, the antenna for the radio or tele-  
vision that is “receiving” the interference).  
Move the unit away from the equipment that is receiving interference.  
Plug the unit into a different wall outlet so that the unit and the equip-  
ment receiving interference are on different branch circuits.  
If these measures do not eliminate the interference, please consult your  
dealer or an experienced radio/television technician for additional sug-  
gestions.  
This limited warranty terminates if you sell or otherwise  
transfer this product to another party.  
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY  
ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE,  
JURISDICTION TO JURISDICTION OR COUNTRY TO COUNTRY. KLIPSCH’S  
RESPONSIBILITY FOR MALFUNCTIONS AND DEFECTS IN HARDWARE IS  
LIMITED TO REPLACEMENT OR REPAIR AS SET FORTH IN THIS WAR-  
RANTY STATEMENT. FOR CANADIAN CUSTOMERS, KLIPSCH DISCLAIMS  
ALL OTHER WARRANTIES AND CONDITIONS, EXPRESS OR IMPLIED,  
STATUTORY OR OTHERWISE, FOR THE PRODUCT. FOR U.S. CUS-  
TOMERS, ALL EXPRESS AND IMPLIED WARRANTIES FOR THE PRODUCT,  
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MER-  
CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED  
IN TIME TO THE TERM OF THIS WARRANTY. SOME STATES, JURISDIC-  
TIONS OR COUNTRIES DO NOT ALLOW THE EXCLUSION OF CERTAIN  
IMPLIED WARRANTIES OR CONDITIONS, OR LIMITATIONS ON HOW  
LONG AN IMPLIED WARRANTY OR CONDITIONS LASTS, SO THIS LIMITA-  
TION MAY NOT APPLY TO YOU. KLIPSCH DOES NOT ACCEPT LIABILITY  
FOR SPECIAL, INDIRECT, CONSEQUENTIAL OR INCIDENTAL DAMAGES,  
INCLUDING WITHOUT LIMITATION, ANY LIABILITY FOR THIRD PARTY  
CLAIMS AGAINST YOU FOR DAMAGES OR FOR PRODUCTS NOT BEING  
AVAILABLE FOR USE. THE MAXIMUM LIABILITY FOR WHICH KLIPSCH  
MAY BE RESPONSIBLE WILL BE NO MORE THAN THE AMOUNT YOU  
Also, the Federal Communications Commission has prepared a helpful  
booklet, “How To Identify and Resolve Radio TV Interference Problems.”  
This booklet is available from the U.S. Government Printing Office,  
Washington, DC 20402. Please specify stock number 004-000-00345-4  
when ordering copies.  
This product complies with DHHS Rules 21 CFR Subchapter J.  
Applicable at the date of manufacture.  
This Class B digital apparatus complies with Canadian ICES-003. Cet  
appareil numérique de la classe B est conforme à la norme NMB-003  
du Canada.  
 
Rubber Feet  
On Wall Use  
DIAGRAM 1  
LCR SPEAKERS  
Table Use  
DIAGRAM 2  
SATELLITES  
Rubber Feet  
DIAGRAM 3  
WALL  
MOUNTING  
LCRs  
DIAGRAM 4  
WALL  
MOUNTING  
SATELLITES  
 
QUINTET SL SPEAKER SYSTEM  
FIGURE 1  
FIGURE 2  
STEREO  
PLACEMENT  
SURROUND LCR  
AND REARS  
FIGURE 3  
FIGURE 4  
PLACEMENT OF CENTER  
CHANNEL WITH TV  
SPEAKER WIRE  
HOOK UP  
(STANDARD)  
Below TV  
on Wall  
Below TV  
on Stand  
 
 
Power  
Detail  
Emotion  
For over 60 years, we’ve made speakers for people who are as passionate about  
great sound as we are. That’s why every Klipsch speaker is horn-loaded to create a  
remarkably accurate listening experience for your music and movies. From our  
smallest satellites to our acclaimed professional theater installations, our speakers  
deliver sound that’s so lifelike, you have to feel it to believe it.  
TM  
1007770  
THE ULTIMATE SOUND EXPERIENCE  
 

Indesit Washer Dryer W83 User Manual
Ingersoll Rand Water Pump 650632 X C User Manual
Intel Fish Finder 150SX User Manual
Invacare Mobility Aid Color Collection User Manual
Jackson Dishwasher Dishmachine Component User Manual
Jasco Home Safety Product 45132 User Manual
Jwin Portable DVD Player Z1055 User Manual
Kenmore Dishwasher 6307793 User Manual
Kenwood Satellite Radio TK 2402 User Manual
Konica Minolta Digital Camera Dynax Maxxum 5D User Manual