Kenwood Toaster TTM322 User Manual

Never use an unauthorised  
attachment or accessory.  
Note:  
4 Lower the lever until it locks. The  
‘cancel’ button will illuminate. (The  
lever will not stay down unless the  
toaster is plugged in).  
For non-rewireable plugs the fuse  
cover MUST be refitted when  
replacing the fuse. If the fuse cover  
is lost then the plug must not be  
used until a replacement can be  
obtained. The correct fuse cover is  
identified by colour and a  
replacement may be obtained from  
your Kenwood Authorised Repairer  
(see Service).  
If a non-rewireable plug is cut off it  
must be DESTROYED  
IMMEDIATELY. An electric shock  
hazard may arise if an unwanted  
non-rewireable plug is inadvertently  
inserted into a 13A socket outlet.  
Never use a damaged toaster. Get it  
checked or repaired: see 'Service'.  
This appliance is not intended for  
use by persons (including children)  
with reduced physical, sensory or  
mental capabilities, or lack of  
experience and knowledge, unless  
they have been given supervision or  
instruction concerning use of the  
appliance by a person responsible  
for their safety.  
Children should be supervised to  
ensure that they do not play with  
the appliance.  
Only use the appliance for its  
intended domestic use. Kenwood  
will not accept any liability if the  
appliance is subject to improper  
use, or failure to comply with these  
instructions.  
To toast frozen bread, once the  
Use the carriage lever to lift the  
toast to Peek & View™ at any  
time without cancelling the toasting  
cycle.  
bread is lowered press the ‘defrost’  
button. The ‘defrost’ button will  
illuminate.  
To warm toast thats popped up but  
before using your Kenwood  
appliance  
Read these instructions carefully  
and retain for future reference.  
Remove all packaging and any  
labels.  
gone cold, lower the toast then  
press the 'reheat' button. The  
‘cancel’ and ‘reheat’ buttons will  
illuminate.  
Use the carriage lever to lift the  
toast to Peek & View™ at any  
time without cancelling the toasting  
cycle.  
safety  
Burnt food can catch fire, so:  
never leave your toaster on  
unattended;  
keep your toaster away from  
anything (eg curtains) that could  
catch fire;  
To stop toasting during the cycle,  
before using for the first time  
1 Clip excess cord into the cord  
storage clips in the base .  
Operate the toaster once on a  
medium setting without bread. (The  
lever will not stay down unless the  
toaster is plugged in).  
press the ‘cancel’ button, the toast  
will pop up and the ‘cancel’ button  
light will go off.  
5 Your toast will pop up  
automatically, to raise it higher, lift  
the lever.  
before plugging in  
set the browning control lower for  
thin or dry bread;  
Make sure your electricity supply is  
the same as the one shown on the  
underside of your toaster.  
As with all new heating elements,  
hints on using your  
toaster  
never warm food with a topping or  
filling (eg pizza): if it drips into the  
toaster, it could catch fire.  
Clean the crumb tray regularly:  
crumbs can smoke or burn.  
To avoid electric shocks, never:  
let the toaster, cord or plug get wet;  
or  
put your hand or anything metal,  
eg a knife or foil, into the toaster.  
Always unplug the toaster when not  
in use, before cleaning or  
attempting to clear jammed bread.  
Never cover your toaster with a  
plate or anything else - it could  
overheat and catch fire.  
Never let the cord hang down  
where a child could grab it.  
We recommend that you do not  
use your toaster directly under wall  
cupboards.  
Do not move the toaster whilst it is  
in operation.  
Never touch hot surfaces especially  
the metal top area.  
your toaster may emit a slight  
burning smell when it is first  
switched on. This is normal and not  
a cause for concern.  
This appliance complies with  
European Economic Community  
Directive 89/336/EEC.  
Select a lower setting for light  
browning, for toasting one slice only  
or for dry bread.  
Important – UK only  
key  
When toasting a single slice of  
The wires in the cord are coloured  
as follows:  
Green and Yellow = Earth,  
Blue = Neutral,  
Peek & View™ carriage lever  
browning control  
reheat button with indicator light  
defrost button with indicator light  
cancel button with indicator light  
crumb tray  
bread, you may notice a variation in  
toast colour from one side to the  
other - this is normal.  
Dry/stale bread toasts more quickly  
Brown = Live.  
than fresh bread and thinly sliced  
bread toasts more quickly than  
thickly sliced bread. Therefore the  
browning control should be set at a  
lower setting than usual.  
The appliance must be protected  
by a 13A approved (BS1362) fuse.  
WARNING: THIS APPLIANCE  
MUST BE EARTHED.  
cord storage  
to use your toaster  
1 Plug the toaster into the power  
supply.  
2 Move the browning control to the  
desired setting. Use a low setting  
for light toasting and for thin or dry  
bread.  
3 Insert the bread, muffins, bagels  
etc.  
For best results ensure that the  
bread slices are of an even  
thickness, freshness and size.  
In order to achieve uniform  
browning we recommend you wait  
a minimum of 30 seconds between  
each toasting so that the control  
can automatically reset. Alternatively  
select a lower setting when  
additional toasting is carried out.  
 

Indesit Refrigerator IN S 1611 UK User Manual
IOGear Mouse GMESKYP1 User Manual
JAI Network Card Vis 300 400 User Manual
JVC Battery Charger VU V856KIT User Manual
JVC Laptop MP XV841DE User Manual
Kalorik Microwave Oven USK MW 26146 User Manual
Karcher Iron SI 2600 CB User Manual
Karcher Pressure Washer G2600XC User Manual
Kenmore Range 79075503 User Manual
Keys Fitness Home Gym 708S User Manual