HM790 series
●
●
●
before using your Kenwood appliance
Read these instructions carefully and retain for future
reference.
If a non-rewireable plug is cut off it must be
DESTROYED IMMEDIATELY. An electric shock hazard
may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
This handmixer complies with European Economic
Community Directive 89/336/EEC.
●
●
Remove all packaging and any labels.
safety
●
Ensure the cord is fully unwound from the cord wrap
before using the handmixer.
Never put the handmixer body in water or let the cord
or plug get wet.
Keep fingers, hair, clothing and utensils away from
moving parts.
before using your handmixer for the first time
Wash the parts (see 'cleaning').
●
●
●
●
key
ቢ
ባ
ቤ
ብ
ቦ
ቧ
ቨ
ቩ
ቪ
ቫ
speed switch
tool release button
beaters
Never let the cord touch hot surfaces or hang down
where a child could grab it.
Never use a damaged handmixer. Get it checked or
repaired: see 'service and customer care'.
Never use an unauthorised attachment.
Always unplug the appliance when not in use, before
fitting or removing parts or before cleaning.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Only use the appliance for its intended domestic use.
Kenwood will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
cord wrap
kneader with additional collar
kneader without additional collar
beater storage pillars
kneader storage pillars
worktop storage unit
cord clip
●
●
●
to use your handmixer
1 Unwrap the cord from the cord wrap and make sure
the speed switch is in the off position by lining up the O
symbol on the handmixer body with the dot on the side
of the speed switch. Insert the beaters or kneaders –
turn and push until a positive click is felt. The tabs on
the tool shafts need to line up with the outlet holes.
Important: The kneader with the additional collar will
only fit into the larger outlet hole.
●
●
before plugging in
2 Plug in.
●
Make sure your electricity supply is the same as the
one shown on the underside of your handmixer.
Important – UK only
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by a 5A approved
(BS1362) fuse.
Note:
For non-rewireable plugs the fuse cover MUST be
refitted when replacing the fuse. If the fuse cover is lost
then the plug must not be used until a replacement can
be obtained. The correct fuse cover is identified by
colour and a replacement may be obtained from your
Kenwood Authorised Repairer (see Service).
3 With the ingredients in a suitably sized bowl, place the
beaters/kneaders into the bowl.
4 Pull the speed switch backwards to reach the desired
speed (the first dot on the handmixer body is slow and
speed 5 is fast). Line up the dot on the side of the
speed switch with the corresponding speed.
●
●
●
As the mixture thickens, increase the speed.
If the machine labours increase the speed.
Move the speed switch forwards to the pulse position
●
●
●
(P) to operate the motor as required. The motor will
operate for as long as the pulse is held in position.
5 When the mixture has reached the desired
consistency, return the speed switch to the off
position and then lift the beaters/kneaders out of the
bowl.
2
6 To remove the tools, make sure the speed switch is in
the off position and unplug the handmixer. Press the
tool release button. Hold onto the tool shafts when
ejecting the tools.
beaters, kneaders
Wash by hand or in your dishwasher, then dry.
●
●
handmixer body and worktop storage unit
Wipe with a dry to slightly damp cloth then dry.
Important:
●
When making bread dough we recommend that the
storage
dough load does not exceed 400g flour.
●
●
1 Wrap the cord around the base of the handmixer ᕡ
and clip the cord together using the cord clip.
2 Place the handmixer on its end into the worktop
storage unit, ensuring the plug and handle are facing
away from the storage pillars ᕢ.
3 Store the beaters in the two outside beater storage
pillars.
4 Store the kneader without additional collar in the taller
of the kneader storage pillars.
With heavy mixtures, such as dough, don’t use your
handmixer for longer than 3 minutes in any 5 minute
period as the protection device might operate. Switch
it off as soon as you’ve got the right consistency.
To protect your handmixer it is fitted with a protection
device which will stop the handmixer operating if
overloaded. If this happens, switch off, unplug, wait a
couple of minutes and then plug back into the power
supply.
5 Store the kneader with additional collar in the shorter of
the kneader storage pillars.
Recommended speeds for beaters
Please note that these are recommendations
only and the speed you select may depend upon
the bowl size, quantities, the ingredients you
are mixing and personal preference.
service and customer care
●
If the cord is damaged it must, for safety reasons, be
replaced by KENWOOD or an authorised KENWOOD
repairer.
Recommended
Food type
speeds
UK
Egg whites
Gradually increase the
speed to 5
If you need help with:
●
using your handmixer or
Cream
1 - 2
●
servicing or repairs (in or out of guarantee)
ట call Kenwood customer care on 023 9239 2333.
Have your model number ready - it's on the
underside of your handmixer.
Whisked sponge
Gradually increase the
speed to 3
1 stage sponge cake
Batter
1 – 3
1
●
spares and attachments
టcall 0870 2413653.
other countries
Rubbing fat into flour
Adding water to combine
pastry ingredients
1
1
●
Contact the shop where you bought your handmixer.
guarantee (UK only)
If your handmixer goes wrong within one year from the
date you bought it, we will repair or replace it free of
charge provided:
you have not misused, neglected or damaged it;
it has not been modified (unless by Kenwood);
it is not second-hand;
it has not been used commercially;
you have not fitted a plug incorrectly; and
cleaning
●
Always switch off, unplug and remove the beaters or
kneaders before cleaning.
●
●
●
●
Never put the handmixer body in water or let the cord
or plug get wet.
Never use abrasives to clean parts.
●
●
●
●
you supply your receipt to show when you
bought it.
This guarantee does not affect your statutory rights.
3
Recipe
white bread dough
400g/14 oz strong plain flour
10ml/2 tsp dried yeast (the type that requires
reconstituting)
5ml/1 tsp sugar
5ml/1 tsp salt
1
13g/ ⁄2 oz lard
230ml/8 fl.oz. warm water
The correct water temperature should be 43°C and can
be achieved by mixing one third boiling water with two
thirds cold.
Place the dried yeast with the sugar and water in a
suitably sized mixing bowl (you may find a smaller bowl
makes the operation easier) and leave to froth. Add the
remaining ingredients. Fit the kneaders to the handmixer
then combine the ingredients together on a low speed
until the flour is incorporated, then increase the speed and
knead until the dough is smooth and elastic for
approximately 1 minute 30 seconds. Leave the dough to
rise in a warm place for 45-60 minutes.
Re-knead the dough on speed 5 for 30 seconds keeping
the kneaders in the mix.
Shape the dough into a loaf or rolls and place on greased
baking trays. Then leave somewhere warm until it has
doubled in size.
Bake at 230°C/450°F/Gas mark 8 for 20-25 minutes (for
a loaf) or 10-15 minutes (for rolls). When ready the bread
should sound hollow when tapped on the base.
4
|