Kambrook Hot Beverage Maker KSK210 User Manual

Profile  
Kettle  
One Touch Pop-Up Lid  
KSK210  
 
KSK210_KETTLE_IB_FA.indd  
1
20/5/09 1:50:07 PM  
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES  
Fully unwind the power cord before use.  
Any maintenance other than cleaning should be  
performed at an authorised Kambrook Service  
Centre.  
Do not let the power cord hang over the edge of  
a bench or table, touch hot surfaces or become  
knotted.  
This appliance is for household use only. Do not  
use this appliance for anything other than its  
intended use. Do not use in moving vehicles or  
boats. Do not use outdoors. Misuse may cause  
injury.  
The appliance is not intended for use by persons  
(including children) with reduced physical, sensory  
or mental capabilities, or lack of experience  
and knowledge, unless they have been given  
supervision or instruction concerning use of  
the appliance by a person responsible for their  
safety.  
The installation of a residual current device (safety  
switch is recommended to provide additional  
safetyprotectionwhenusingelectricalappliances.  
It is advisable that a safety switch with a rated  
residual operating current not exceeding 30mA  
be installed in the electrical circuit supplying the  
appliance. See your electrician for professional  
advice.  
Children should be supervised to ensure that they  
do not play with the appliance.  
It is recommended to regularly inspect the  
appliance. To avoid a hazard do not use the  
appliance if power cord, power plug or appliance  
becomes damaged in any way. Return the entire  
appliance to the nearest authorised Kambrook  
Service Centre for examination and/or repair.  
 
KSK210_KETTLE_IB_FA.indd  
3
20/5/09 1:50:08 PM  
KNOW YOUR KAMBROOK STAINLESS STEEL 1.7L KETTLE  
5
3
8
4
2
1
7
6
1
5
2200 Watt concealed element  
1.7Litre capacity  
Locking hinged lid  
2
6
Multi-directional cordfree power base  
Power on switch and light  
Lid release button  
3
7
Removable filter  
4
8
Water window  
 
KSK210_KETTLE_IB_FA.indd  
4
20/5/09 1:50:16 PM  
5. The kettle will automatically switch ‘OFF’ once  
the water has boiled. Lift the kettle from the  
power base and pour the water. Take care to  
hold the kettle level, especially when filled  
to the maximum level. To re-boil it may be  
necessary to wait for a few seconds to allow  
the control to reset.  
OPERATING INSTRUCTIONS  
OPERATING YOUR KAMBROOK  
STAINLESS STEEL 1.7L KETTLE  
BEFORE FIRST USE  
Remove any packaging material and promotional  
labels before using your kettle for the first time.  
The kettle should be stored on its power base when  
not in use. The power outlet should be switched  
off and the power cord unplugged from the power  
outlet when not in use.  
It is recommended that before the first use to fill  
the kettle to the maximum level with cold tap  
water, bring to the boil and then discard the water.  
Your kettle will only operate when positioned on  
the power base with the ON/OFF switch in the ON  
position. The kettle will automatically switch off  
once the water has boiled.  
Caution: this applianCe is designed for the boiling  
of drinking quality water only, never use it to heat  
or boil any other liquids or foodstuffs. the lid  
should always be firmly in plaCe and loCked Closed  
before use.  
OPERATION OF YOUR KETTLE  
1. To fill the kettle with water, remove it from the  
power base and open the lid by pressing the  
button on the top lid of the kettle and lifting  
the lid upwards. Fill with the desired amount of  
water. Do not operate the kettle without water.  
Always fill the kettle between the minimum and  
the maximum marks on the water window. Too  
little water will result in the kettle switching off.  
Caution: do not release the lid while the water is  
boiling. ensure the lid is Closed whilst boiling.  
SAFETY BOIL DRY PROTECTION  
The kettle is fitted with a safety device, which  
protects against overheating should the appliance  
be operated with insufficient water. If this occurs  
the kettle will stop heating and automatically  
switch off.  
2. Ensure that the lid is closed and locked firmly  
into place before placing the kettle on the  
power base.  
Should this occur, switch off at the power outlet  
and unplug. Allow kettle to cool before refilling.  
When the kettle has cooled down, the safety  
device can be reset by removing and then replacing  
the kettle on its base.  
3. Place the kettle firmly onto the power base. Plug  
the power cord into 230/240V power outlet and  
switch ‘ON’.  
4. Press the ON/OFF switch to the ‘ON’ position.  
The power ‘ON’ light will illuminate.  
NOTE: Never operate the kettle dry - too little water  
will result in the kettle switching “OFF”.  
Do not overfill the kettle - filling above the maximum  
mark on the water window may result in boiling  
water splashing from the kettle.  
NOTE: This kettle must only be used with the power  
base supplied. Use caution when pouring water  
from your kettle, as boiling water will scald. Do not  
pour the water too quickly.  
NOTE: Do not remove the kettle from the power  
base during operation. Ensure the kettle has  
switched to ‘OFF’ position after the water has  
boiled before removing the kettle from the power  
base.  
 
KSK210_KETTLE_IB_FA.indd  
5
20/5/09 1:50:16 PM  
REMOvING MINERAL DEPOSITS  
CARE AND CLEANING  
Mineral deposits in tap water may cause the kettle  
interior and water window to discolour over time. This  
may be removed by using a proprietary kettle descaler  
which is available from most leading supermarkets,  
department stores and hardware stores.  
Always switch off at the power outlet, and then  
unplug the appliance from the power outlet before  
cleaning.  
CLEANING THE KETTLE ExTERIOR  
The outside stainless steel surface of the kettle  
may be wiped over with a damp cloth and polished  
with a soft, clean dry cloth.  
ALTERNATIvELY:  
1. Fill the kettle until 23 full with 1 part vinegar (or  
a few slices of lemon) and 2 parts water, bring  
to the boil and allow to stand overnight.  
Note: Do not use chemical, steel wool, or abrasive  
cleaners to clean the inside or outside of the kettle.  
2. Empty the solution from the kettle. Fill the kettle  
with clean water, bring to boil and discard the  
water. Repeat and the kettle will be ready  
for use.  
Caution: to prevent damage to the applianCe do  
not use alkaline Cleaning agents when Cleaning, use  
a soft Cloth and mild detergents.  
STORAGE  
warning: never immerse the kettle base, switCh  
area, power base or power supply Cord in water, or  
allow moisture to Come in ContaCt with these parts.  
Ensure the kettle is switched off, cleaned and  
dried before storing. Ensure that the lid is closed  
and locked firmly into place. Wrap the power cord  
around the cord storage under the power base.  
Stand the kettle upright on the power base. Do not  
store anything on top.  
CLEANING THE REMOvABLE FILTER  
The Kambrook Stainless Steel 1.7L Kettle features  
a removable mesh filter to filter out scale deposits  
for cleaner water. To remove the scale deposits,  
remove the filter by opening the lid of the kettle.  
Pull the filter firmly to remove.  
The filter can be cleaned by running under hot  
water and rubbing with a soft cleaning cloth or  
brush. To replace the filter, simply press the filter  
down firmly into the slot behind the spout of the  
kettle.  
TIP: The filter could become damaged with time,  
please check regularly and replace if found  
damaged.  
Note: Ensure the kettle and water have cooled  
down before attempting to clean the filter.  
MINERAL DEPOSITS AND  
DISCOLOURATION  
Due to the large surface area of the concealed  
element interior base, discolouration due to mineral  
deposits from tap water may appear more obvious by  
leaving a brown stain on the base. THIS IS NOT RUST.  
To remove the discolouration, follow the  
instructions “Removing mineral deposits”.  
 
KSK210_KETTLE_IB_FA.indd  
6
20/5/09 1:50:16 PM  
NOTES  
 
KSK210_KETTLE_IB_FA.indd  
7
20/5/09 1:50:17 PM  
KAMBROOK 12 MONTH REPLACEMENT WARRANTY  
Kambrook warrants the purchaser against defects in workmanship and material for a period of 12 months  
from the date of purchase (3 months commercial use).  
Guarantee and purchase receipt for this product are to be retained as proof of purchase and must be  
presented if making a claim under the Kambrook guarantee.  
Kambrook reserves the right to replace or repair the appliance within the warranty period.  
Warranty does not apply to any defect, deterioration, loss, injury or damage occasioned by, or as a result  
of the misuse or abuse, negligent handling or if the product has not been used in accordance with the  
instructions. The guarantee excludes breakages and consumable items such as kneading blades.  
This warranty is void if there is evidence of the product being tampered with by unauthorised persons.  
If the product includes one or a number of accessories only the defective accessory or product will be  
replaced. In the event of Kambrook choosing to replace the appliance, the guarantee will expire at the  
original date, i.e. 12 months from the original date of purchase.  
In Australia, this KAMBROOK Guarantee is additional to the conditions and guarantees which are mandatory  
as implied by the Trade Practises Act 1974 and State and Territory legislation.  
For service, spare parts or product information in Australia, please call KAMBROOK on the Customer  
Service Line; 1300 139 798.  
For service, spare parts or product information in New Zealand, please call KAMBROOK on the New Zealand;  
0800 273 845 or 09 271 3980.  
If claiming this guarantee the product must be returned freight prepaid.  
KAMBROOK 12 MONTH REPLACEMENT WARRANTY  
Attach a copy of the purchase receipt here.  
YOUR PURCHASE RECORD (Please complete)  
DATE OF PURCHASE .......................................................  
MODEL NUMBER .............................................................  
SERIAL NUMBER .............................................................  
(Please don’t return purchase record  
PURCHASED FROM .........................................................  
until you are making a claim)  
Kambrook - New Zealand  
Private Bag 94411  
Greenmount, Manukau  
Auckland 2141  
New Zealand  
Customer Service Line/Spare Parts 0800 273 845  
or 09 271 3980  
Kambrook - Australia  
Building 2, Port Air Industrial Estate  
1A Hale Street  
Botany NSW 2019  
Australia  
Customer Service Line 1300 139 798  
Customer Service Fax 1800 621 337  
Customer Service Fax 0800 288 513  
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the illustration in this book. Issue 1/09  
 
KSK210_KETTLE_IB_FA.indd 12  
20/5/09 1:50:04 PM  

Intel Computer Hardware PM915 478 User Manual
JBL Professional Car Speaker LSR4326P User Manual
JVC Car Stereo System KD A725 User Manual
JVC Car Stereo System LVT1982 002A User Manual
JVC Digital Camera GR DF565 User Manual
Kenmore Washer 1104418 User Manual
Kenwood Car Speaker KFC HQ570 User Manual
Kenyon Ventilation Hood B83211 User Manual
KitchenAid Range YKGRT500 User Manual
KitchenAid Recording Equipment KEMS306X User Manual