Kambrook Fan KFA413 User Manual

Arctic  
40cm  
Pedestal Fan  
Instruction Booklet  
KFA413  
 
Kambrook Recommends Safety First  
IMPORTANT: Please retain your  
instruction book for future use.  
At Kambrook, we believe that safe performance is the first priority in any  
consumer product, so that you, our valued customer can confidently  
use and trust our products. We ask that any electrical appliance that  
you use be operated in a sensible fashion with due care and attention  
placed on the following important operating instructions.  
Important Safeguards For Your Kambrook  
Arctic Pedestal Fan  
• Carefully read all instructions before  
operating the Kambrook Arctic  
Pedestal Fan for the first time and save  
for future reference.  
• Do not unplug the fan by pulling on  
the cord.  
• Never leave the fan unattended when  
in use.  
• To protect against electric shock, do no  
immerse the fan, cord or plug in water  
or any other liquid  
• This fan is intended for household  
use only and not for commercial or  
industrial use. Disconnect the power  
plug before dismantling, assembling or  
before cleaning and when the fan is  
not in use.  
• Never carry the fan by the cord or yank  
to disconnect from an outlet; instead,  
grasp the cord and pull to disconnect.  
Do not pull the cord around sharp  
edges or corners.  
• Avoid touching mobile parts of the fan.  
• Ensure the fan is on a dry and  
even surface.  
• Never insert fingers, pencils or any other  
objects through the guards whenever  
the power plug is connected, in  
particular while the fan is switched on.  
• The fan must not be used if the guards  
are not fastened correctly, according  
to these instructions.  
• Do not operate in the presence of  
explosives and/or flammable fumes  
or liquids.  
3
 
Important Safeguards For All  
Electrical Appliances  
• Fully unwind the power cord before use.  
• Any maintenance other than cleaning  
should be performed at an authorised  
Kambrook Service Centre.  
• Do not let the power cord hang over  
the edge of a bench or table, touch  
hot surfaces or become knotted.  
• To protect against electric shock do not  
immerse the power cord, power plug or  
housing in water or any other liquid.  
• The appliance is not intended for use  
by persons (including children) with  
reduced physical, sensory or mental  
capabilities, or lack of experience  
and knowledge, unless they have  
been given supervision or instruction  
concerning use of the appliance by a  
person responsible for their safety.  
• This appliance is for household use only.  
Do not use this appliance for anything  
other than its intended use. Do not use  
in moving vehicles or boats. Do not use  
outdoors. Misuse may cause injury.  
• The installation of a residual current  
device (safety switch) is recommended  
to provide additional safety protection  
when using electrical appliances. It  
is advisable that a safety switch with  
a rated residual operating current  
not exceeding 30mA be installed in  
the electrical circuit supplying the  
appliance. See your electrician for  
professional advice.  
• Children should be supervised  
to ensure that they do not play with  
the appliance.  
• It is recommended to regularly inspect  
the appliance. To avoid a hazard do  
not use the appliance if power cord,  
power plug or appliance becomes  
damaged in any way. Return the  
entire appliance to the nearest  
authorised Kambrook Service Centre  
for examination and/or repair.  
4
 
Your Kambrook Arctic Pedestal Fan  
1. Fan blade size: 40cm  
2. Choice of 3 speed settings  
Parts List  
9. Front grille with securing clips  
and screw  
10. Rear grille  
3. 80° oscillation to disperse the air  
throughout the room  
4. Easy twist controller switch  
11. Blade cap and guard locking nut  
12. Plastic fan blade  
13. Motor head and stand  
14. Pedestal extension tube  
15. Height adjustment ring  
16. 2 piece criss-cross base  
5. Height adjustable for  
comfort control  
6. Tilt adjustable head to control the  
direction of the air  
7. Metal grille and plastic blades  
8. Convenient carry handle for  
easy portability  
5
 
Using Your Kambrook Arctic Pedestal Fan  
Before First Use  
Fan Head Assembly  
Remove any promotional material from  
the fan.  
1. Remove the Blade Cap from the  
Motor shaft by turning it clockwise,  
and then remove the Guard Locking  
Nut by turning it anti-clockwise.  
IMPORTANT: When  
2. Thread the Motor shaft through  
the centre hole of the Rear Grille,  
placing the Rear Grille into position.  
Make sure that the carry handle, on  
the back of the Rear Grille is located  
above the motor housing. Ensure  
the Rear Grille is aligned with the  
locating pins and fix the grille into  
position by replacing the Guard  
Locking Nut. Make sure that the Rear  
Grille has not slipped off the locating  
pins before tightening. This should be  
done by hand. Do not force.  
unpacking the fan, check  
to see you have received  
all the items listed in the  
Parts List, before discarding  
the packaging.  
Assembling Your Arctic  
Pedestal Fan  
Base and Pedestal Tube Assembly  
1. Remove the four screws from the  
criss-cross bars, and align these  
four holes with those on the flange.  
Secure the flange to the criss-cross  
bars with the four screws. This might  
require a bit of force.  
NOTE: When positioning the  
Rear Grille on the Motor shaft,  
always ensure the carry handle  
on the grille is positioned in the  
upright position.  
3. Insert the Plastic Blade onto the  
Motor shaft, and match the pin slots  
in the blade with the Motor shaft pin.  
4. Fix the blade into place by  
tightening the Blade Cap onto the  
Motor shaft in an anti-clockwise  
direction. This should be done by  
hand. Do not force.  
Fig. 1  
5. Unlatch the Securing Clips on the  
Front Grille and unscrew the small  
screw located at the bottom of the  
front guard.  
2. Loosen the Height Adjustable Ring  
and extend the support tube. A bit  
of force may be required to grasp  
the support tube, located inside the  
Pedestal Extension Tube. Retighten  
the Height Adjustment Ring to  
prevent slipping.  
6. Press together the Front and Rear  
Grille, and secure by snapping shut  
the Securing Clips over edges of  
both grilles. Make sure that the small  
holes at the bottom of both grilles  
are aligned. Tighten the Securing  
Clips by hand.  
3. Place the motor head housing onto  
the Pedestal Extension Tube.  
7. Thread the screw through the  
small holes of both the front and  
back grilles, and tighten using the  
nut provided.  
4. Tighten the screw to secure the  
Pedestal Extension Tube to the  
motor head housing.  
6
 
Setting the Oscillation  
The oscillation function works in all air  
flow settings.  
Press down the Oscillation switch to  
activate. The fan will begin to oscillate  
from side to side.  
Lift the Oscillation switch to stop the fan  
from oscillating.  
Fig. 2  
NOTE: The Oscillation switch is  
located behind the Rear Grille,  
on the Motor head housing.  
To Operate the Arctic  
Pedestal Fan  
Adjustable Tilting Head  
Plug the cord into a 230V or 240V power  
point and switch on.  
The Arctic Pedestal Fan incorporates  
an Adjustable Tilt Head for greater  
air coverage.  
NOTE: To avoid an electrical  
circuit overload, it is  
recommended that no other  
appliances are plugged into the  
same circuit as your fan when it  
is in use.  
To adjust the angle of the head, while  
securely holding the shaft of the  
pedestal tube, simply lift or lower the  
Motor head housing, the head will click  
as it is being adjusted.  
Adjustable Height  
The Arctic Pedestal Fan height can be  
adjusted.  
Use the Twist Controller Switch to select  
the desired air flow speed setting.  
Simply loosen the Height Adjustable Ring  
on the Pedestal Tube of the fan. Then  
adjust to the required height. Re-tighten  
the Height Adjustable Ring when the  
desired height has been reached.  
0 – The fan is in the ‘OFF’ position  
1 – Low  
2 – Medium  
3 – High  
Care and Maintenance  
Always switch the Arctic Pedestal Fan  
off, prior to cleaning the housing, base,  
grilles and blades.  
To clean the outside of the fan, wipe  
the exterior with a soft, damp cloth.  
Never use an abrasive cleaner.  
When not in use, store the fan  
(preferably in its original box) in a cool,  
clean and dry location.  
Fig. 3  
7
 
Kambrook 12 Month Replacement Warranty  
In Australia, this Kambrook Replacement  
Warranty does not affect the mandatory  
The Kambrook Replacement Warranty does not  
apply to any defect, deterioration, loss, injury or  
statutory rights implied under the Trade Practices damage occasioned by, or as a result of, misuse  
Act 1974 and other similar State and Territory  
legislation relating to the appliance. It applies  
in addition to the conditions and warranties  
implied by that legislation.  
or abuse, negligent handling or if the product  
has been used other than in accordance with  
the instructions. The Kambrook Replacement  
Warranty excludes breakables such as glass and  
ceramic items, consumable items and normal  
wear and tear.  
In New Zealand, this Kambrook Replacement  
Warranty does not affect your mandatory  
statutory rights implied under the Consumer  
This Kambrook Replacement Warranty is void if  
Guarantees Act 1993 in relation to the appliance. there is evidence of the product being tampered  
It applies in addition to the conditions and  
guarantees implied by that legislation.  
with by unauthorised persons.  
If the product includes one or a number of  
This Kambrook Replacement Warranty is valid only accessories only the defective accessory or  
in the country of purchase, but other statutory  
warranties may still apply.  
product will be replaced. Subject to your statutory  
rights, in the event of Kambrook choosing  
to replace the appliance, the Kambrook  
Replacement Warranty will expire at the original  
date, i.e. 12 months from the original date of  
purchase.  
This Warranty card and the purchase receipt  
for this product are to be retained as proof of  
purchase and must be presented if making  
a claim under the Kambrook Replacement  
Warranty. Please note that under any applicable  
statutory warranty you are not required to  
produce these documents, but may be required  
to provide a proof of purchase.  
In the event that you need some assistance  
with your Kambrook appliance, please contact  
our Customer Service Department on 1300 139  
798 (Australia) or 09 271 3980 (New Zealand).  
Alternatively, visit us on the website at  
Kambrook warrants the purchaser against defects  
in workmanship and material for a period of 12  
months domestic use from the date of purchase  
(or 3 months commercial use).  
Kambrook 12 Month Replacement Warranty  
Your Purchase Record (Please Complete)  
Attach a copy of the purchase receipt here.  
Date Of Purchase ________________________________  
Model Number ___________________________________  
Serial Number ____________________________________  
(Please don’t return purchase record  
until you are making a claim)  
Purchased From __________________________________  
Kambrook - New Zealand  
Private Bag 94411  
Botany, Manukau  
Auckland 2141  
New Zealand  
Customer Service Line/Spare Parts  
0800 273 845 or 09 271 3980  
Kambrook - Australia  
Building 2, Port Air Industrial Estate  
1A Hale Street  
Botany NSW 2019  
Australia  
Customer Service Line 1300 139 798  
Customer Service Fax 1800 621 337  
Customer Service Fax 0800 288 513  
Due to continual improvement in design or otherwise, the product you  
purchase may differ slightly from the illustration in this book. Issue A10  
 

Intel Laptop W476 User Manual
Intellinet Network Solutions Network Card 524438 User Manual
Jasco Universal Remote RM24908 User Manual
JVC Furnace GR DVL9000 User Manual
JVC Home Theater System 1080p User Manual
JVC MP3 Player XA F107B User Manual
JVC Projector DLA HD1 User Manual
Keating Of Chicago Pasta Maker 24763 User Manual
Kenmore Dishwasher 2335998811 User Manual
Kenmore Water Dispenser 625343420 User Manual