INSTALLATION & USER GUIDE
For Precise Volume
Adjustment in All
Weather Conditions
V-12/AWE
12-STEP ALL WEATHER ENCLOSED VOLUME CONTROL
FEATURES
I Includes PVC weatherproof housing and stainless steel hardware
I Safely connect up to eight speaker pairs to a single amplifier or receiver
I UL listed to comply with local building codes
I Stylish indicator knob
I 12-step make before break volume control switch design
Installation friendly design:
I Accepts up to 14-gauge wire
I Snap and lock connector secures wire in place without the use of a screwdriver
I Mounts easily to any surface or directly on PVC conduit
1
PRODUCT OVERVIEW
e
d
c
b
V-12/AWE
(a) Knob
(b) Faceplate
(c) Gasket
(d) Volume Control
(e) Enclosure
a
Figure 1
2
PACKAGE CONTENTS
PREPARING FOR INSTALLATION
I V-12/AWE Volume Control x 1
I Knob x 1
Consider the most convenient location to mount the
V-12/AWE. Use the PVC junction box (supplied),
mounted atop a PVC conduit through which the wires
will run. Count the number of pairs of 4 ohm speakers
and the number of pairs of 8 ohm speakers you are
connecting. Count pairs of 6 ohm speakers as 4 ohm
pairs. Determine the correct switch position from the
impedance charts. See figures 2, 3 and 4.
I Device mounting screws x 2
I Snap and lock removable speaker connectors x 2
I Standard faceplate screws x 4
I Enclosure x 1
I Gasket x 1
Figure 3
Figure 4
Figure 2
3
Using Speaker Selectors with IM
Muting Volume Controls
INSTALLATION
1. Identify the Speaker wire and Amplifier wire.
Label the wires for future reference.
Although IM controls provide volume and on/off at
the volume-control location, they do not give you
central control of speakers playing throughout the
house. Speaker-selection systems give you central
control, but some speaker selectors have non-
defeatable impedance-protection circuits. Combining
IM controls with such a selector will reduce your
maximum volume substantially. To solve this problem,
specify a speaker selector with a defeatable
2. Run the necessary wiring up through the conduit
and the opening at the base of the enclosure.
3. Mount the entire enclosure atop the PVC conduit.
Secure the enclosure with galvanized mounting
screws.
4. Strip 1/4" of insulation from the end of each wire.
Tightly twist the end
of each wire until no
protection circuit (JobSite models S-4 or S-6). Then
keep the protection circuit off at all times.
frayed ends remain.
Tools Required
5. Locate the snap and
lock connectors and
remove them if they
are plugged in. See
figure 5.
Figure 5
I 1/8" Slotted screwdriver
I 1/4" Slotted screwdriver
I No2 Phillips screwdriver
I Wire stripper
I Wire labels
4
6. Use a small flathead screwdriver or your thumb to
raise the locking tabs, exposing the holes on the
connector.
INSTALLATION DIAGRAM
7. Insert each wire into the appropriate hole and
snap down the locking tabs.
8. Insert the smooth side of the connector plug into
the smooth side of the V-12/AWE socket.
Input From
Amplifier
V-12/AWE
9. Install the V-12/AWE into the all-weather
enclosure.
10. Set the Impedance Magnification Switch as
determined by the impedance charts.
V-12/AWE
Side View
11. Set the switches, on all of the controls, to the
same position (1x, 2x, 4x, or 8x).
Output to
Speakers
12. Attach the cover plate.
See installation diagram.
Stereo Receiver
5
Speakers
OPERATION
reached the limit of your amplifier’s volume
capability. Reduce the volume at once to avoid
damaging your speakers.
1. Make sure the amplifier or receiver power is OFF
and set the volume to minimum.
6. Use the volume control to adjust the volume of the
speakers to the desired listening level. If all the
speaker pairs in your system are equipped with
JobSite volume controls, you can set the amplifier
or receiver volume at one position and use the
JobSite controls exclusively.
2. Set the volume on the volume control to maximum
(fully clockwise).
3. If you are using a JobSite speaker-selection
system, locate the on/off button that corresponds
to the speaker pair you wish to play. Set it to the
ON position. Make sure the defeatable protection
circuit is not enabled. See Using Speaker
7. To turn OFF the speakers, turn the knob on the
volume control fully counter-clockwise, or press
the ON/OFF button on your speaker selector.
Selectors with IM Volume Controls, on page 5.
4. Turn ON the amplifier or receiver and select a
source, such as the Tuner or CD player.
5. Slowly turn up the amplifier or receiver volume and
set it to a comfortable – not maximum – listening
level. Don’t overdrive or "clip" your amplifier. If the
sound becomes muddy or distorted, you have
6
SPECIFICATIONS
Dimensions:
3" wide x 4-13/16" high x 3-3/8" deep
High power rating:
100 watts per channel RMS, 200 watts peak
Depth behind faceplate:
2-9/16"
Adjustable impedance:
1x, 2x, 4x, 8x settings
Warranty: 10 year limited
Total attenuation:
54dB maximum
Wiring requirements:
2 individual runs of 2-conductor 14-18-gauge
speaker wire or 1 run of 4 conductor
Mounting:
Surface mount PVC single gang enclosure
(included), mounts on 3/4" PVC conduit
7
LIMITED WARRANTY
manufacturing defects in material and workmanship
for a period of five years from date of purchase.
JobSite Systems (“JOBSITE”), a Niles Audio
Corporation company, warrants its passive products
(those not requiring AC or battery power) to the
original purchaser to be free of manufacturing
defects in material and workmanship for a period of
ten years from date of purchase.
JOBSITE warrants its active products (those
requiring AC or battery power) to the original
purchaser to be free of manufacturing defects in
material and workmanship for a period of two years
from date of purchase.
This Warranty is subject to the following additional
conditions and limitations. The Warranty is void and
inapplicable if JOBSITE deems that the product has
been used or handled other than in accordance
with the instructions provided by the manufacturer,
including, but not limited to, damage caused by
accident, mishandling, improper installation, abuse,
negligence, or normal wear and tear, or any defect
caused by repair to the product other than by
JOBSITE or an authorized JOBSITE wholesale
distributor.
JOBSITE warrants its passive loudspeaker products
(those not requiring AC or battery power) to the
original purchaser to be free of manufacturing
defects in material and workmanship for a period of
five years from date of purchase.
JOBSITE warrants its indoor/outdoor loudspeaker
products to the original purchaser to be free of
manufacturing defects in material and workmanship
for a period of two years from date of purchase.
JOBSITE warrants its all weather rock loudspeaker
products to the original purchaser to be free of
To obtain warranty service, you must write to
8
JOBSITE: Include your name, address, telephone
number, model number and serial number of your
unit, and a brief description of the problem.
A factory Return Authorization Number will be sent
to you. DO NOT RETURN ANY UNIT WITHOUT
FIRST RECEIVING WRITTEN AUTHORIZATION AND
SHIPPING INSTRUCTIONS FROM JOBSITE.
REPAIR OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF
THE CONSUMER/PURCHASER. NILES SHALL NOT
BE RESPONSIBLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES EXCEPT TO THE
EXTENT PROVIDED (OR PROHIBITED) BY
APPLICABLE LAW.
If the above conditions are met, the purchaser’s
sole remedy shall be to return the product to
JOBSITE, in which case JOBSITE will repair or
replace, at its sole option, the defective product
without charge for parts or labor. JOBSITE will
return the unit repaired or replaced under warranty
by shipping it by its usual shipping method from the
factory (only) at its expense within the United States
of America. THERE ARE NO OTHER WARRANTIES,
INCLUDING, WITHOUT LIMITATION, EITHER
EXPRESS OR IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A
Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the
above limitation may not apply to you. This warranty
gives you specific legal rights, and you may also
have other rights, which vary from state to state.
For the name of the nearest authorized JOBSITE
wholesale distributor, contact:
JobSite Systems
12331 S.W. 130 Street, Miami, Florida 33186
WWW.JOBSITESYSTEMS.COM
PARTICULAR PURPOSE, WITH RESPECT TO
THE PRODUCT.
9
JOBSITE SYSTEMS
12331 S.W. 130 STREET, MIAMI, FLORIDA 33186
P 866.4JB.SITE (866.452.7483) – F 305.238.0185
WWW.JOBSITESYSTEMS.COM
© 2004 JobSite Systems. All rights reserved. JobSite, Pure Custom and Niles are registered trademarks of Niles Audio Corporation and the JobSite Logo
is a trademark of Niles Audio Corporation. All other trademarks are the property of their respective owners. Some JobSite products (or components
thereof) are manufactured under one or more U.S. Patents, foreign equivalents and/or pending patents (see product for details). Because we constantly
strive to improve our products, JobSite reserves the right to change product specifications, descriptions, and prices without notice. The technical and
other specifications of information contained herein are not intended to set forth all technical and other specifications of JobSite products. Additional
information can be obtained at WWW.JOBSITESYSTEMS.COM or by calling JobSite at 866.452.7483. Printed in China. 7/04 DS00397BCN
|