Aftermarket Head Unit
SYSTEM 8:
Audiophile Single-
Subwoofer System
This is a perfect setup for the
customer who wants the highest
levels of sound quality but is not
interested in huge bass.
300/2
The single 12W3 in the
CS112-W3 provides strong output
and excellent bass quality without
taking up a ton of trunk space. It's
driven by a 250/1 monoblock.
The four XR systems (XR650-CS
in the front, XR650-CX in the rear)
are cleanly driven by the 300/2.
This system is shown connected
to a single pair of line level outputs
at the head unit. In this configuration,
front-to-rear fading is not possible
and subwoofer level must be
carefully preset.
XR650-CS
(Left Front)
XR650-CS
(Right Front)
8Ω 25w
8Ω 25w
Resistor
Resistor
250/1
XR650-CX
(Left Rear)
XR650-CX
(Right Rear)
CS112-W3
(Subwoofer)
RCA Cable (pair)
SpeakerWire
Remote Lead
Recommended initial amplifier settings for this system...
Adjust "Input Sens." to
achieve desired output
level from subwoofer
Set "Filter Freq."
to "80" (24 clicks)
Adjust "Boost" to
"+3" initially
Connect to input
of 300/2 Amplifier
Connect to head unit
line level output
Connect to
CS112-W3
= POSITION
Adjust "Input Sens."
to achieve desired output
level from front speakers
Set "Filter Freq." to
80 Hz (15 clicks)
This section is not
used in this application
Connect to 250/1 Left Speaker output to both left speakers (8Ω resistor inline with rear)
preamp outputs Right Speaker output to both right speakers (8Ω resistor inline with rear)
Note: These settings are intended as a “baseline” for tuning this system. Depending on the vehicle and the customer’s
tastes, some variation in the crossover and bass control settings may be necessary for optimum performance.
|