INSTALLATION INSTRUCTIONS
VR900/VR904 VANDAL RESISTANT TRIM
FOR USE WITH MORTISE LOCKS (ON PULL SIDE OF DOOR)
LOCATE AND PREPARE ALL TRIM HOLES
AS SHOWN ON TEMPLATEꢀ
PREPARE DOOR FOR MORTISE LOCKꢀ SEE MORTISE
LOCK INSTRUCTIONS FOR PREPARATIONꢀ
5
1
2
ALIGN TRIM TEMPLATE WITH HORIZONTAL
CYLINDER CENTER LINE (C ) ON PULL SIDE EDGE
L
OF DOOR AND SECURE WITH TAPEꢀ
VR900 TRIM
TEMPLATE
RHR SHOWN
LHR OPPOSITE
SECURE TRIM TO PULL SIDE OF DOORꢀ
6
VR900/VR904 TRIM
MARK THE CENTER POINT OF EACH HOLE
WITH A PUNCHꢀ
3
4
1/4” COUNTERSINK
WASHERS (4)
USING A SQUARE, TRANSFER THE 4
MOUNTING HOLE LOCATIONS TO THE
OPPOSITE SIDE OF THE DOORꢀ
HOLE DIMESIONS AND PREPARATION
ARE SHOWN ON TEMPLATEꢀ
SCREWS (4):
1/4-20 X 1-3/8”
OPHMS SCREWS
(1-3/4” DOORS)
WHEN USING A BEVELED
DOOR, MAKE SURE TO
MEASURE HOLES FROM
THE FURTHEST EDGE AS
SHOWN
1/4-20 X 1-3/4”
OPHMS SCREWS
(2-1/4” DOORS)
RHR SHOWN
LHR OPPOSITE
SEE MORTISE LOCK INSTRUCTIONS FOR
MORTISE LOCK AND CYLINDER INSTALLATIONꢀ
7
CYLINDER COLLAR
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
829562_00(3) Copyright © 2003 Ingersoll-Randꢀ All rights reservedꢀ
|