Solara jr.™ VentilatorTray
Assembly,Installation and Operating Instructions
Kit No.1108526
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact Carrier/Invacare
for further instructions.
SAFETY SUMMARY
To ensure the safe and proper installation and use of the Ventilator Tray, these instructions
MUST be followed:
GENERAL WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet and the Solara jr. Owner’s Manual, part number 1106628. If
you are unable to understand the warnings, cautions and instructions, contact a
healthcare professional, dealer or technical personnel if applicable, before
attempting to install this equipment - otherwise, injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely.
NOTE: The ventilator tray kit can only be installed on 16-inch wide Solara jr. wheelchairs. If necessary,
adjust the width of the wheelchair. Refer to the Solara jr. Service Manual, part number 1106629.
This kit includes the following items:
Description
Quantity
Plug Button
Washer
Locknut
Side Mounting Screw
Ventilator Tray with six (6) Straps
Rear Ventilator Tray Crossmember
2
2
2
2
1
1
Part No. 1106665
1
Solara jr.™ Ventilator Tray
DETAIL “A”
REAR Ventilator Tray Crossmember (STEP 9)
Plug Buttons (STEP 5)
Mounting Screw (STEPS 6 and 9)
Tilt Slide Housing (STEP 6)
Side Mounting Screw (STEP 1)
REAR
Crossmember
(STEP 2)
UPPER Frame Tube (STEP 8)
FRONT Crossmember Mounting
Screw (STEP 3)
Locknut
(STEP 6)
Washer (STEP 1)
Side Mounting
Screw (STEP 1)
Locknut (STEP 3)
FRONT Crossmember
CENTER Crossmember Mounting
Screw (STEP 4)
CENTER Crossmember
Locknut (STEP 4)
DETAIL “B”
REAR Upright
FRONT Mounting Screws (STEP 10)
Ventilator Tray
(STEP 7)
FRONT of
Ventilator Tray
(STEP 10)
Locknut (STEP 12)
Washer (STEP 12)
Side Mounting
Screw (STEP 12)
CENTER Mounting
Screw (STEP 11)
FRONT Locknut (STEP 10)
Side Mounting Tab
(STEPS 7 and 12)
CENTER Locknut (STEP 11)
CENTER Fold (STEP 7)
FIGURE 1 - INSTALLING THE VENTILATOR TRAY
Part No. 1106665
3
Solara jr.™ Ventilator Tray
USING THE VENTILATOR TRAY (FIGURE 2)
NOTE: The ventilator tray straps are installed on the ventilator tray before the ventilator tray is shipped.
1. Position all six (6) strap slides on the outside of the ventilator tray.
2. Position the ventilator battery in the front portion of the ventilator tray.
3. Secure the two (2) battery straps around the top of the ventilator battery and clip together.
4. Position the ventilator in the rear portion of the ventilator tray.
5. Secure the four (4) ventilator straps around the top of the ventilator and clip together.
6. Adjust the slides, located in the middle of each strap, up or down to increase or decrease
length. See DETAIL “C”.
7. Securely tighten the straps around the battery and ventilator by pulling the ends of the
straps through the rear portion of each buckle. See DETAIL “D”.
DETAIL “C”
Strap
DETAIL “D”
Strap
Rear
Portion
Slide
of Buckle
Rear Portion of Ventilator Tray
Ventilator Straps
Ventilator Straps
Battery Strap
Battery Strap
Slides
Front Portion of Ventilator Tray
FIGURE 2 - USING THE VENTILATOR TRAY
USA
Canada
One Invacare Way
Elyria, Ohio USA
44036-2125
570 Matheson Blvd. E Unit 8 Invacare is a registered trademark of
Mississauga Ontario
L4Z4G4 Canada
800-668-5324
Invacare Corporation.
Yes, you can. and Solara jr. are
trademarks of Invacare Corporation.
© 2001 Invacare Corporation
Rev A 03/02 Part No. 1106665
800-333-6900
|