Quick Setup Guide NS-PU98635/NS-PU98635-C
I
USB 3.0 to Gigabit Ethernet Adapter
Thank you for purchasing this high quality Insignia USB 3.0 to Gigabit
Ethernet Adapter. Use this adapter to instantly connect to a 1000 Mbps
network from the USB 3.0 port on your desktop or laptop computer.
3 When installation is complete, click Finish, then restart your
computer.
SETTING UP THE ADAPTER
Note: The driver software must be installed before you connect the adapter.
The adapter does not need to be connected for the software to install. If the
computer has Windows 8.1, you do not need to install the driver from the disc.
The drivers are installed automatically.
PACKAGE CONTENTS
To install on a Windows PC:
1 Insert the driver CD into your computer’s disc drive. The installation
wizard should open.
Note: If the wizard does not run automatically, locate and double-click
Run.exe on the driver CD.
•
•
•
USB to Ethernet Adapter
Driver CD
Quick Setup Guide
2 Click on your operating system, then follow the on-screen
instructions.
SYSTEM REQUIREMENTS
•
Windows® 8.1, Windows® 8, Windows® 7, Windows Vista®
OR
Mac OS 10.4.X or higher
Available USB port
•
4 Connect the USB connector on the adapter to an open USB port on
your computer.
5 Connect a network cable to the Ethernet port on the adapter.
To install on a Mac:
1 Insert the driver CD into your computer’s disc drive.
2 In the Finder, select RTUNICv1.0.8 under DEVICES, then open
RTUNICv1.0.8.pkg. The driver setup wizard opens.
RTUNICv1.0.8
RTUNICv1.0.8.pkg
RTUNICv1.0.8
Before using your new product, please read these instructions to prevent any damage.
|